E N G L I S H
• Never clamp around a conductor
at 600V rms or greater or with a of
10KHz frequency or greater.
• Never use a meter whose insulating
protection has been impaired.
• Be extremely cautious when
clamping
around
conductors or bus bars.
• Use this Meter only as specified
in this manual. Otherwise, the
protection provided by this Meter
may be impaired.
• Observe the safety messages
contained in this manual.
• Avoid working alone.
• Inspect the test leads for damaged
insulation or exposed metal. Check
test lead continuity. Damaged leads
should be replaced.
• Disconnect the live test lead before
disconnecting the common test lead.
• Be sure this Meter is in good
operating
condition.
continuity test, a meter reading
that goes from overflow (OFL) to
0 generally means this Meter is
working properly.
• Select the proper function and
range for your measurement.
3. EXPLANATION OF
CONTROLS AND INDICATORS
1. CLAMP.
Opens 2.04 inches (52mm) to enclose
conductors.
2. HOLD.
Freezes reading in digital display.
3. DISPLAY.
Liquid crystal display.
4. RANGE.
Selects 0 to 40A, 0 to 400A, or AUTO.
24
5. ON-OFF.
Selects meters power ON or power
OFF.
uninsulated
During
a
6.
Selects continuity testing mode.
7. .
Selects
mode.
8. V .
Volt, Resistance, Continuity Test Input
Terminal.
9. V.
Selects volts measurement mode.
10. COM.
Common terminal.
11. Hz.
Selects
mode.
.
resistance
frequency
measurement
measurement