General MSV350D Manual Del Usuario página 7

metal object is detected, the scanning bars Icon
will appear from bottom. When the full scanning
bars Icon with steady tone sound appears, a
metal object is close to the sensor head. To
pinpoint the exact position after the metal has
been located, press the scan button once which
is located on the left side of main body of the
unit and repeat the above procedures.
VOLTAGE DETECTION
Check that there is no source of electricity in the
immediate vicinity. Then press and release
selector switch until icons appears on the LCD
screen. At this moment, auto calibration for
voltage detection will start by displaying the
scanning bars from bottom of the scanning
indicators. This procedure will complete when
the scanning Indicators show a full scale of
reading and disappear quickly. At the same time,
the scan symbol will display on the LCD screen
with a short "beep" tone. The instrument is now
ready for voltage scanning.
Voltage Scanning
Hold the instrument horizontally with the sensor
head pointing towards the wall (see Figure 4) and
sweep systematically over the required area. If a
source of voltage is detected, the scanning bars
Icon will appear from bottom. Once a full
scanning indicators icon with steady tone sound
appears. This represents a source of voltage is
close to the sensor head. To pinpoint the exact
position after a voltage carrying object has been
located, press the scan button once and repeat
the above procedures.
Electrical
Wire
Figure 4
7