Installing The Strainer - Conglom QL110 Manual Del Usuario

Installation (continued)

INSTALLING THE STRAINER

- Apply plumbing putty or silicone
sealant to the top side of the
drain opening .
- Insert the strainer body (1) into the
drain opening and press it down until it
is evenly seated .
- Assemble the rubber gasket (2), fiber
washer (3) and strainer locknut (4) onto
the strainer body (1) from underneath
the sink . Hand tighten the strainer
locknut (4) until it is snug. Do not
overtighten .
- Insert the plastic flange (5) into the
flange-end of the tailpipe (6) (not
supplied) then secure the tailpipe to
the strainer body using the connecting
nut (7). Tighten the connecting nut (7)
until it is snug . Do not overtighten .
- Remove excess sealant from around
the drain opening .
QL110
Sink
Fig. 14
12
Strainer Basket
Strainer Body (1)
Sealant
Rubber Gasket (2)
Fiber Washer (3)
Strainer Locknut (4)
Plastic Flange (5)
Tailpipe (6)
(not supplied)
Connecting Nut (7)