Charging Curve - BS Charger BS 15 Manual De Instrucciones

Smart Charging Mode
There are following stages:
•
Sof start Charging Mode (C.C. Mode)
-
Blue Charging LED is flashing.
-
Gently ramps up the battery voltage to 11V
• Bulk Charging Mode (C.C. Mode)
-
Blue Charging LED is ON.
-
The battery can be charged about 80%.
-
The charger delivers an almost constant current 1500mA until the battery voltage reaches the set value.
• Absorption Mode (C.V Mode)
-
Blue Charging LED is ON.
-
The battery can charge up to almost 100%.
-
The charging current tapers and the charging voltage are kept constant at the set value.
•
Analysis Mode ( Battery retention test Mode)
-
The charging is interrupted for a short period for battery voltage measured
-
If the battery voltage falls too quickly, the battery is probably faulty.
-
The Yellow Charging LED is ON (if above situation occurred)
•
Float Mode (Safe voltage level of 13.6V)
-
Full Green LED is ON.
-
The Float Mode allows the charger to effectively be left connected to your batteries; it works at a safe level of 13.6V, and ready
for use.
• Maintenance mode (Special pulse for long term maintenance)
-
Full Green LED is ON.
-
The program engages a special charging waveform and monitors the battery voltage variety, if the battery voltage sinks, the
special pulses will keep the battery in optimal state, if the battery voltage drops even lower, the battery charger will switch into
Bulk charging stage. The maintenance mode allows the charger can be connected to the battery over the course of a season;
if possible; check the electrolyte liquid level in the battery.
LED STATUS INIDICATOR TABLE
LED Status
Power / Fault LED – Green / Red
Green ON
Green Flash
Red ON
Charge / Reconditioning LED – Blue / Yellow
Blue Flash
Blue ON
Yellow ON
Full LED -Green
Green ON

CHARGING CURVE

Initial Rejuvenation Soft Start
Qualification
VOLTAGE
(V)
CURRENT
(Amps)
• Initial qualification: test automatically battery condition and determine if chargers engages rejuvenation or charging cycle.
• Rejuvenation: rejuvenates sulphated batteries with a high frequency pulse.
• Soft start: increases battery life by gently starting to charge the battery.
•
Bulk charge: reduces charging time by delivering maximum charge to set voltage.
•
Absorption: ensures a full charge to the battery without overcharging.
• Battery test: tests the battery to ensure fully charged.
• Float: float charge maintains the battery at 100% charge. 21 days restart.
• Long term maintenance: if the battery voltage sinks, the special pulses will keep the battery in optimal states.
| www.bs-battery.com
Description
AC power is connected
ECO mode and no battery presented
Short –circuit or Reverse polarity
Recondition / Soft start
Bulk charge (C.C) mode / Absorption charge (C.V) mode
Battery is flat (less than 2V)
The charger is at Float mode (Full)
STAGE
Bulk Absorption Battery
Charge test
Float Long Term
Maintenance
6