Front & Rear Panels - Cortex MIX-R1U Guia De Funcionamiento

2
6
10
1. MAIN POWER INLET SWITCH
This section is for the AC power connection, The MIX-R1U comes with a stan-
dard 3 prong AC power cord and has an auto switching internal power
supply. once hooked up properly you can switch the on off switch to the
ON position.
2. MAIN OUT L/R XLR CONNECTORS (BALANCED)
XLR type balanced stereo audio output. These connectors output audio sig-
nal generated from the MIX-R1U unit
3. AUX OUT L/R 1/4" CONNECTORS (UNBALANCED)
1/4" type unbalanced stereo audio output. These connectors output the
main output signal of the MIX-R1U unit.
4. AUX OUTPUT VOLUME CONTROL
This mini rotary volume controls the AUX OUTPUT volume.
5. RECORD OUTPUT
A third output, with no volume control and set to output at a consistent level
for recording. Use this to connect to a recording device.
6. MICROPHONE INPUTS
The MIX-R1U has two microphone inputs, one located on the front panel,
and one on the back. Both are controlled by the same microphone volume
control rotatry which is also located on the front panel. The volume rotary
features an on/off switch built into its design, so when you pull the knob out
it will "click" to the on position and the blue LED will turn on indicating the
microphone channel is ON. There is also a TALKOVER switch which will lower
the main volume when pressed allowing for better microphone clarity,a blue
LED will illuminate indicating the TALKOVER is engaged.
4
6
3
5
11
12
13
8
Rear Panel
7
Front Panel
14
11
12
13
7. CONVERTIBLE PHONO/LINE SWITCHES
The MIX-R1U has 2 CONVERTIBLE PHONO/LINE (PH/LN) RCA SWITCHES
These small switches which are located to the right of the RCA inputs for
channels 1 and 2 allow you to choose between a PHONO (Turntable) input
or a LINE level (Mp3, CD, Tape player etc..).and require the proper switch-
ing. When switched to the PH position you may use any Turntable with a
magnetic cartridge, remember to connect your ground wire (see GROUND-
ING SCREW) or there may be a system hum And when the switch is in the
LN position you may connect any line level device as described before
(Mp3, CD, Tape etc).
NOTE: CONNECTING A LINE LEVEL DEVICE TO A PH INPUT MAY CAUSE
THAT MIXER CHANNEL TO OVERLOAD AND OR DISTORT.
8. CHANNEL INPUTS
Now you may plug the RCA's from your playable medium into each input to
be connected to their respective CHANNELS (CH).
9. GROUNDING SCREW
When using a turntable(s), you will need to ground the RCA cable(s) by
screwing in the grounding fork(s) to the GROUNDING SCREW located on
the rear panel of the MIX-R1U.
10.CHANNEL INPUT SELECTOR
The CHANNEL INPUT SELECTOR switches allow you to choose which input
will be controlled by that channels corresponding volume rotary.
For example on CHANNEL (1) the INPUT SELECTOR allows you to choose
between PHONO 1/LINE 1 and LINE 2 , and also on CHANNEL (2) the
INPUT SELECTOR SWITCH allows you to choose between PHONO 2/ LINE
3 and LINE 4.
Setup Guide
Front & Rear Panels
9
15 16 18
10 17
1
4