Tabla de contenido
Enlaces rápidos
Tabla de contenido
Manuales relacionados para UI SUNMAX SolarPoint SM-SP-40
Resumen de contenidos para UI SUNMAX SolarPoint SM-SP-40
- Página 1 SolarPoint 4x PoE Smart MPPT Charger Model: SM-SP-40...
-
Página 2: Package Contents
• Shielded Category 5 (or above) cabling should be used for all wired Ethernet connections • We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. For more details, visit: ui.com/toughcable... -
Página 3: Hardware Overview
Hardware Overview PV Panel Ethernet System Battery Ports Terminal Terminal Output PV Panel Reset Power Terminal Button Terminal Description Interface Steady on when system is powered on; System LED Red when battery polarity is reversed. Press and hold the Reset button for 10 seconds to restore factory default settings. -
Página 4: Hardware Installation
Hardware Installation Note: Prior to use, it is recommended to write down the factory default password for this device. The password can be found on the sticker located under the SolarPoint cover. Pole Mounting 1. Open the Metal Strap and feed it through the mounting slots on the back of the SolarPoint. -
Página 5: Wall Mounting
Wall Mounting 1. Attach the two wall mount brackets to the back of the SolarPoint. 2. Install the wall mount level securely to the wall. - Página 6 3. Align the wall mount brackets over the wall mount level and slide it down until it is secure.
- Página 7 Opening the Port Cover 1. Press down and slide the port cover forward. 2. Lift the port cover up.
- Página 8 3. Remove the four-pin connector from the battery terminal block. 4. Crimp a ferrule on one end of the wire. 5. Insert the crimped wire into the appropriate slot on the four-pin connector. Using a flathead screwdriver, secure the wire to the connector by tightening the screw until it stops.
- Página 9 6. Repeat steps four and five until the connector is fully occupied with all four wires. 7. Attach the NTC and battery cable using the four-pin connector. 8. Attach the PV panel cables.
- Página 10 Connecting Ethernet 1. Connect Ethernet cable(s) to the Ethernet port(s). Note: PoE is disabled by default and can be enabled using the configuration interface. 2. When you are finished, close the port cover.
-
Página 11: Configuration
Configuration Connect to your LAN via Ethernet or Wi-Fi. Ethernet If connected to the LAN via Ethernet, the SolarPoint will attempt to obtain an IP address automatically from a DHCP server. Use the Ubiquiti Device Discovery Tool to determine its IP address. If there is no DHCP server on the LAN, the SolarPoint will fall back to the following IP address: 192.168.1.20 Wi-Fi... - Página 12 4. Click Set Device Location to set the location for your solar system installation. 5. Click Power on the Settings screen and fill out the battery and solar panel information. Enabling PoE To enable PoE on the SolarPoint: 1. Click Output on the Settings screen. 2.
- Página 13 Specifications SM-SP-40 Dimensions 202 x 186 x 50 mm (7.95 x 7.32 x 1.97") Weight 650 g (1.43 lb) Enclosure Characteristics UV-Resistant Polycarbonate, Outdoor Use Max. Power Consumption Networking Interface (4) 10/100 Fast Ethernet Ports Management Interface Ethernet Wi-Fi (2.4 GHz) Button Reset LEDs...
-
Página 14: Safety Notices
Limited Warranty ui.com/support/warranty The limited warranty requires the use of arbitration to resolve disputes on an individual basis, and, where applicable, specify arbitration instead of jury trials or class... - Página 15 Compliance Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.
- Página 16 IMPORTANT NOTE: Radiation Exposure Statement: • This equipment complies with radiation exposure limits set forth for an uncontrolled environment. • This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body. • This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
- Página 17 RoHS/WEEE Compliance Statement English European Directive 2012/19/EU requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams.
-
Página 18: Declaration Of Conformity
2014/53/EU, 2014/30/EU, 2014/35/EU. Úplné znění EU prohlášení o shodě je k dispozici na této internetové adrese: ui.com/compliance Dansk [Danish] Hermed, UBIQUITI, erklærer at denne SM-SP-40 enhed, er i overensstemmelse med de væsentlige krav og øvrige relevante krav i direktiver 2014/53/EU, 2014/30/EU, 2014/35/EU. EU-overensstemmelseserklæringens fulde tekst kan findes på følgende internetadresse: ui.com/compliance... - Página 19 2014/53/UE, 2014/30/UE, 2014/35/UE. Le texte complet de la déclaration UE de conformité est disponible à l’adresse internet suivante: ui.com/compliance Deutsch [German] Hiermit erklärt UBIQUITI, dass sich dieses SM-SP-40 Gerät, in Übereinstimmung mit den grundlegenden Anforderungen und den anderen relevanten...
- Página 20 în conformitate cu cerințele esențiale și alte prevederi relevante ale Directivelor 2014/53/UE, 2014/30/UE, 2014/35/UE. Textul integral al declarației UE de conformitate este disponibil la următoarea adresă internet: ui.com/compliance Slovenčina [Slovak] Týmto UBIQUITI, prehlasuje, že toto SM-SP-40 zariadenie, je v súlade so základnými požiadavkami a ďalšími relevantnými ustanoveniami smernice...
- Página 21 685 Third Avenue, 27th Floor New York, NY 10017 Support help.ui.com Community community.ui.com Downloads downloads.ui.com ©2019 Ubiquiti Inc. All rights reserved. Ubiquiti, the Ubiquiti U logo, the Ubiquiti beam logo, sunMAX, SolarPoint, TOUGHCable, and UNMS are trademarks or registered trademarks of Ubiquiti Inc.