Trevi SF 200 Manual De Usuario página 20

SF 200
If the pairing pop‐up do not appear within 1 minute, repeat the above steps. There would be a Bluetooth icon
instead of the Radar icon
6.SYNC Data
The bracelet SYNC data automatically after connected with phone by APP (Zeroner), the bracelet time will be
calibrated same as the time of phone. SYNC data includes :steps, calories, distance. You can check out if the
data SYNC is completed successfully on the APP. First SYNC data takes 1‐2 minutes. SYNC data can be done
manually by clicking the refresh button on APP. Where unable to be data synchronous, disconnected the
Bluetooth, try connection again and start data synchronization.
7.Sleep monitor
Turn on Sleep Mode：Slide to the moon icon , long press the icon till the band shakes, then it pop up and
shows time and moon icon, , it means under sleeping mode.
Exit the sleep mode：Long press the screen to light‐on the screen, long press once more till it shakes, then the
moon icon will disappear and back to the original that shows time , it means sleeping‐mode exit.
8.Auto sleeping mode
Turn on the sleeping‐mode by setting, , the band will check if you are under sleeping‐mode during
8:00p.m.‐9:00a.m.
9．Looking mobile phone
Long press the looking phone icon till in shakes, the searching mobile will ring if it is under ringing
mode, will shakes one time if it under vibration mode.
10.Sedentary reminder
Open the Sedentary reminder and settle the time quantum by the
Sedentary reminder setting, the time settling should be a valid time quantum, like 9:00‐17:00 instead of
9:00‐5:00, then it under Sedentary reminder mode successfully. The band will shakes and
shows sedentary icon if keep motionless for an hour.
20