Error Messages And Fault Clearance - RK Rose+Krieger RKMultiControl duo accu Instrucciones De Montaje

7. Working life

7.16 Error messages and fault clearance

If there is a fault, an error code appears in the hand switch display (e.g. "E002"). The error codes
with their meanings are listed in the table below.
No error messages are displayed in the 2-key hand switch!
Indication
E000
As delivered state
E002
System overload
E004
Duty cycle exceeded
E006
Voltage is too low
The number of drives has been
E010
changed during operation.
E021
Difference between drives 1 and 2
An audible alarm warns the user
Beep before the battery discharges
completely in battery mode.
60
Fault
Perform initialisation run (see section 7.7.2)
If the fault is appearing frequently, check your system for
mechanical overload.
Wait until the error message goes out.
With Firmware 2.15: Pull out the mains plug, wait for 30
seconds and plug it back in again.
From Firmware 2.16 and later: The error message stays on
while low voltage is still detected in the control unit.
Pull out the mains plug, check the connections and per-
form an initialisation run (see section 7.7.2)
A difference between the drive connected in socket 1 and
that, for example, connected to socket 3 has been
detected (in this case error Perform an initialisation run.
If the error message is still present, the control unit or a
drive may be faulty.
The battery should be charged by plugging in the mains
plug.
Fault rectification
E022
is indicated).