ShredStar Multishred one-4 all Instrucciones De Servicio página 8

4 Operation
• Set the sliding switch for automatic
operation to "ON/AUTO".
ON/AUTO OFF REV
• Only insert one fl oppy disk or
one CD or one credit card or
max. 8 sheets of paper.
Cutting system starts
automatically.
The material is drawn in and
destroyed. The cutting device
then switches off.
Only then load the next material.
Swit ching Multishred off
• Set the sliding switch to "OFF".
ON/AUTO OFF REV
5 Troubleshooting
Paper jam, device shutdown
• If you feed in to much material (for
example 2 CDs overlap in the cut-
ting device), the device switches off
ON/AUTO OFF REV
automatically.
• Set the slider switch to "REV"
After a delay of 2 seconds, the cutting device
runs in reverse and the material is pushed out.
• Set the slider switch to "ON/AUTO" again.
• Do not put in more material than is allowed.
Shredded material container
Check the level in the shredded material con-
tainer and empty it in good time, as otherwise
the function of the cutting device could be
impaired.
For all other malfunctions, check whether the
cutting head was correctly positioned on the
shredded material container before contacting
our customer service. If the motor was over-
loaded, let the shredder cool down for 30 min-
utes before using it again.
8
6 Cleaning
Switch off the shredder and pull out the mains
plug.
When cleaning only use a soft cloth and a mild
soap-water solution. However, no water must
enter the equipment.
7 Disposal / Recycling
Electrical and electronic old devices
contain a variety of valuable materi-
als, but also hazardous substances
which were required for function and
safety. Incorrect disposal or handling
can be dangerous to your health and
the environment. Never dispose of old devices
in the household waste. Observe the current
applicable regulations and use the collection
points for returning and recycling electric and
electronic devices. Dispose of all the packaging
materials also in an environmentally-responsi-
ble way.
02/2011