Before First Use - Beper 50.971 Manual De Instrucciones

Steam station Use instructions
Front & Rear support
You can put the iron on the front & rear support during operation and you can also secure the iron into front &
rear support for storage after finishing ironing.
Power button
Plug in the appliance and press down the Power button, the power indicator will be illuminated, also the low
steam level regarded as defaulted one and its indicator will flash. Press down the Power button for a while, both
the power indicator and low steam level indicator will be extinguished, and the appliance will be disconnected
from the power supply.
Steam level control button
The steam level can be selected low, medium or high with the steam level control button. Any one to be selected,
its indicator will flash, after a few minutes, the indicator will be changed to illuminating. At this time, the appliance
can produce steam and you can use the steam for ironing.
Temperature dial
Turn the dial to set ironing temperature to meet the garment changed.
Temperature indicator
When the iron is heating up, the temperature indicator will be illuminated. Once the iron has reached the selected
temperature, it will extinguish. The temperature indicator will be cycled on and off as the iron maintains the se-
lected temperature during ironing.
Steam trigger
After pressing down the Power button and choosing the desired steam level, it indicates the steam can be used
for ironing until the corresponding steam level indicator is changed flashing to illuminating. At this time, press
the steam trigger with a little force, the steam will be sprayed from the soleplate continuously. When loosen the
steam trigger, the appliance can only be used for dry ironing without steam.
Lack of water indicator and reset button:
If less water in the tank, the indicator will be illuminated, following with two beeps can be heard, the steam gene-
rator stops working. It prompts you need to add water into the tank.
If less water in the tank, the lack of water indicator will be illuminated, at that time, you need to refill the water
tank. After refill the water tank with water, press the reset button once to make the lack of water indicator be
extinguished and then you can release steam for ironing.
ANTI-CALC FILTER INDICATOR
The item is equipped with anti-calc filter.
Once the anti calc indicator is turned on, replace the filter. Before changing it, put the filter in the water for one
hour. After changed, press for some seconds the steam level control button (4) and the reset one (6) at the same
time. The anti-calc indicator will turn off.

BEFORE FIRST USE

1. Remove any sticker, protective foil or storage cover from the soleplate.
2. Heat up the iron to maximum temperature and iron over a piece of damp cloth for several minutes for the
purpose of removing any residue on the soleplate according to the section of "Steam ironing".
3. Before first use, detach the de-calc box and then immerse it into the water for more than one minute.
NOTE: It is normal that strange odor comes out from the unit for the first use. This will cease after a short while.
NOTE: Some particles may come out of the soleplate when you use the iron for the first time. This is normal; the
particles are harmless and stop coming out of the iron after a short while.
NOTE: When you switch on the appliance, the steam generator may produce a pumping sound. This is normal;
the sound tells you that water is pumped into the steam generator.
NOTE: During the heating process of the soleplate, there will be little steam coming out from the soleplate auto-
matically and this phenomenon will continue for about 3 seconds, This is normal.
10