AccuMate PRO 5
IMPORTANT : Read completely before using the charger.
WARNING! Batteries emit EXPLOSIVE GASES - prevent flame or sparks near batteries and do not smoke.
Protect the charger from dirt and damp. Battery acid is highly corrosive. In case of skin contact wash imme-
diately with soap and water. Wear eye protection and protective clothing when handling batteries. Distance
batteries being charged as far as reasonably possible from the charger to minimise the highly corrosive
effects of acidic battery fumes and fluids. Ventilate the area well. Do not balance the charger on a vehicle
or other irregular surface, place it firmly on a hard flat surface (but not on textile, plastic or leather) or use
the fixing kit provided to fix the charger to a wall. Do not place batteries or any other object on top of the
charger. Do not use the charger unless all cables and connection components are in good condition. Do not
connect the charger to batteries whose terminal posts are loose. Clean corroded posts with a copper wire
brush, and dirty posts with a rag damped in detergent. Before charging batteries with filler caps check that
the electrolyte level is correct and if necessary, top up with distilled water. Protect the charger and its
cables and accessories from dirt, damp and from contamination by acid or acid fumes. Damage caused by
contamination or oxidation is not covered by warranty.
CONNECTIONS : This charger is delivered with five sets of detachable battery connection sets with alli-
gator clips. A number of optional connection accessories are available including a 2,5m 2 x 1.3mm
extension lead set, order reference TM-73 AMEXTEND. Batteries to be charged should be removed from the
vehicle or wiring circuit and placed with the charger in a well ventilated area. Prevent entry of dirt or damp
into the two-pole connectors.
IMPORTANT : It is essential to ensure a good contact between the charger and the battery posts. When you
attach the battery clips to the battery posts wiggle them slightly to ensure a firm and secure contact. Check
that the battery clips are well apart & not in contact with each other or those of neighbouring stations. Always
connect the charger to the batteries to be charged, (red clip to positive or red post, then black clip to negative
or black post) before making the connection to the wall socket (AC power). Disconnect in reverse order.
FUSES : Each of the 5 charging stations is protected individually against anomalies in the mains electrical
input by a fuse. Should one of these 5 fuses blow, replace it only with an identical type of 2A 250V MT.
The following details apply to each of the 5 charging stations individually.
1
2
When correct connections are made and the input power is live, the RED Power On LED should light together
with the YELLOW LED if the battery needs some charging. If the battery is completely sulfated (but never-
theless still measures > 2V), or already fully charged the GREEN LED may light immediately. If the RED
"wrong connections" LED lights, disconnect from the wall socket, correct the connections at the battery,
then reconnect at the wall socket. The charger is electronically protected against wrong battery connec-
tions and no damage will result.
2
Instructions for Use
LED indications
3
4
1 RED
2 RED
3 YELLOW
4 GREEN
CHARGING
www.accumate.com
Power ON
Wrong battery connections
Bulk charging
Maintenance mode
2
output