Setting Up The Appliance; Energy Saving - Tensai CVL120 Manual De Instrucciones

1. The GREEN AND YELLOW wire must be connected
to the terminal in the plug which is marked with the
letter "E" or by the Earth symbol or coloured green or
green and yellow.
2. The BLUE wire must be connected to the terminal
To ensure that the appliance operates properly and to reduce
energy consumption, it is important that the appliance is
installed correctly.
Ventilation
The compressor and condenser generate heat and, therefore,
need to be ventilated properly. Rooms with no ventilation are not
suited for installation of the appliance. Therefore, it should be
installed in a room with an opening (window or French window) that
provide the appropriate amount of air re-circulation. It is also
important to install it in a free humidity room.
During installation, make sure not to cover or obstruct the grates
that allow for proper ventilation of the appliance. For proper
ventilation of the appliance, leave a space of at least 10 cm
between the sides of the appliance and any adjacent
cabinets/walls.
Away from Heat
Avoid positioning the appliance in a place where it is directly
exposed to sunlight or near an oven, cook top or the like.
Levelling
Install the appliance on a level and rigid floor. If the floor is not
perfectly horizontal, adjust the appliance better you can.
A - Electronic Thermostat
Adjust the temperature inside the appliance.
B - Removable Shelves (maximum load: 40 kg per unit)
Before starting the appliance, follow the installation instructions
(see "Safety" and "Installation").
Before connecting the appliance, clean the compartments and
accessories with lukewarm water and bicarbonate.
Insert the plug into the socket.
Adjust the temperature to the required temperature setting.
At this point the appliance can be used.
Using the freezer to its full potential
The temperature inside the appliance compartment automatically
adjusts itself according to the thermostat parameters.
The Cooling system is positioned on top of inside in the freezer.
It´s possible during the operating of the appliance, this wall may be
covered by ice or water drops, depending if compressor was
operating or stopped.
Install the appliance correctly
This means that the appliance should be installed away from
sources of heat or direct sunlight, in a well-ventilated room.
Correct temperature settings
Set the temperature knob to one of the medium settings. Very low
temperatures will not only consume a great deal of energy, but will
neither improve nor lengthen the storage life of the food.
4
Installation
The Appliance

Setting Up the Appliance

Efficient Usage of the Appliance

Energy saving

which is marked with the letter "N" or coloured black.
3. The BROWN wire must be connected to the terminal
which is marked with the letter "L" or coloured BROWN
or RED which is connected to the fuse.
Electrical and Earth Connection
The appliance should not be turned on right after transportation.
Two hours is the advised time so that the oil from the motor-
compressor gets back to its original position.
Before proceeding with the electrical connection, make sure that
the voltage indicated on the rating plate, located inside the
appliance, corresponds to the mains voltage and that the socket is
fitted with a standard earth wire in accordance with safety
standards. If the socket is not fitted with an earth wire, the
manufacturer will not be held liability for any damages and or
injuries arising out of the use of the appliance. Do not use multiple
sockets or adapters.
Position the appliance in such a way that you can access the
socket where it is plugged in.
Insufficient Power
The electrical socket must be able to handle the maximum power
load of the appliance, which is indicated on the rating plate located
inside the appliance.
C – Castor
NOTICE
Use average temperature settings to ensure optimum
performance and to save energy.
If, after closing the door of the appliance, you cannot open the door
again, wait two to three minutes for the pressure to stabilize and
become easy to open again.
Some models may not have all the functions described.
This situation is normal and should not be of concern.
Place only cold or lukewarm foods in the compartment, not hot
foods or soft drinks.
Remember that cooked foods do not last longer than raw foods.
Do not store liquids in open containers. They will increase humidity
in the freezer and cause condensation to form.
Shut the doors
Open your appliance only when strictly necessary – every time you
open the door most of the cold air will be lost. In order to restore
the correct temperature, the motor will have to run and consume
energy.
Check the door seals
Keep the seals clean and pliable so that they fit closely against the
door to ensure that no cold air is lost.