Premier ED-5627 Manual De Instrucciones página 16

corresponds with the power supply details shown on the appliance model label.
Never allow the heating base or the kettle to make contact with or be immersed in water. However,
should this happen, have the unit examined by a qualified service centre before using id again.
In order to comply with safety regulations and to avoid hazards, repairs of electrical appliances must be
carried out by qualified personnel, including the replacement of the power cord. If repairs are needed,
please send the appliance to our customer service department.
Do not operate the appliance if
---the appliance or power cord show any signs of damage
---the appliance has been dropped
Always remove the plug from the wall socket
----after use
---in case of any malfunction
----before cleaning
When removing the plug from the wall socket, never pull on the power cord. Children do not recognize
the dangers that may occur when operating electrical appliances. Therefore keep children away from
such appliances.
Do not attempt to remove any parts of the housing or insert any metal objects into the interior of the
appliance.
To prevent damage to the power cord, do not let it pass over sharp corners or edges. Do not position the
appliance or power cord on or near hot operate the appliance outdoors or with wet hands.
Use only clean cold water, and let the water run for approx two minutes before filling. The appliance
operates at very high temperatures. Caution: there is danger of scalding from escaping water or steam.
Do not touch any part of the kettle expect the handle(7) when the appliance is in use and ensure that the
lid(1) is properly screwed. This appliance is designed for beating water only. Never put any other liquid
into the kettle.
When using the appliance, always pay attention to the water level marking(6)on the outside of the kettle.
Do not let the water level drop below the minimum level and do not exceed the maximum level.
Always place the appliance on a firm and level surface.
If electric kettle is no water, please don't open "on/off" switch.
OPERATION GUIDELINES
Before using for the first time
Prior to initial use, clean it by going through several boiling cycles, using clean water with each cycle and
filling the kettle(2) to its upper marking. The water will reach boiling point after approximately 5 minutes,
when the unit switches off automatically.
Operation
Place the heating base (4) on a firm and level surface
Pour the desired amount of clean water into the kettle(2). Don't touch any part of the kettle expect the
handle (7)when the appliance is in use, and ensure that the lid(1)is properly closed. The amount of water
can be measured by the level mark (5)on the outside of the kettle. Always pay attention to the minimum
and maximum levels and ensure that the lid(1)is properly and firmly closed.
Position the kettle in such a way on the base (4) that the underside of the kettle fits precisely onto the
contact unit on the base.
Insert the plug (5) into a wall socket
Put the on/off switch (8) to its "on" position to start the heating process. The indicator lamp(3)will light up.
As soon as the water reaches boiling point, the on/off switch (8) return automatically to the "off" position.