Perel CCTVSET10 Manual Del Usuario página 16

7.3.5.6 PTZ
Use the PTZ Setup menu to configure settings for a connected PTZ camera (not included).
NOTE: Consult the instruction manual of your PTZ camera for complete information about your
camera, including protocol and baud rate.
To configure a PTZ camera:
1) Connect a PTZ camera to the BNC and 485A (TX, +) and 485B (RX, -) ports and power outlet.
For more details on connecting a PTZ camera.
2) Under PROTOCOL, select PELCO-D or PELCO-P for the selected channel. Click NEXT PAGE for
additional channels (8-channel models only).
3) Under BAUD RATE, select 1200, 2400, 4800, or 9600.
4) Under DATA BIT select 5, 6, 7, or 8.
5) Under STOP BIT, select 1 or 2.
6) Under VERIFY, select ODD, EVEN, MARK, SPACE, or NONE.
7) Under ADDRESS, enter an address from 001~255 using the Virtual Keyboard. Refer to your
PTZ camera`s instruction manual for further details.
8) Click APPLY. Click CLOSE in the confirmation window.
9) Click EXIT in all menus until all windows are closed.
7.3.5.7 NETWORK
Use the Network Setup menu to configure your network and DNS settings.
UPNP
UPnP Forum is an industry initiative designed to enable simple and robust connectivity among
consumer electronics, intelligent appliances and mobile devices from many different vendors.
NOTE: the router needs to support UPNP function.
To configure UPNP settings:
1) Enable the UPNP function in your Router.
2) Under DVR GUI, Open the MAIN MENU and click ADVANCE.
3) From the Advanced Setup menu, click NETWORK.
4) Under UPNP, select OPEN.
5) Click APPLY to save your settings and then click OK in the confirmation window.
6) Using a remote PC, open Internet Explorer.
7) In the address bar, enter your Router WAN IP address immediately followed by: WEB PORT (no
spaces).
http://XXX.XXX.XXX.XXX(Router WAN IP):XXX(WEB PORT)
8) Enter your system ADMIN password and select INTERNET.
NOTE: If you have not enabled passwords on the system, leave the password field blank.
9) Click LOGIN.
To configure network settings:
1) Under TYPE, select DHCP, PPPoE, or STATIC.
If DHCP, go to step 5. If PPPoE, go to step 2, if STATIC, go to step 3.
NOTE: DHCP allows you to quickly connect to your network by obtaining an IP address from the
router. After the initial setup, we recommend that you disable DHCP and set the IP address
between 1~100. For example, if your IP address is 192.168.0.107, change the last digits to
90 (i.e. 192.163.0.90). This ensures that port forwarding will not change in the event of
power failure or resetting of your network.
26/05/2011
CCTVSET10
Figure 2.4.2.18.1 network setup
16
©Velleman nv