Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4
Maintenance
When performing any maintenance the following should
be adhered to:
1
No maintenance should ever be carried out whilst the
machine is operating.
The machine should be unplugged.
2
The instructions contained in the manual should be strictly
3
adhered to.
4
Use original spare parts.
4.1
Changing the belt
In order to check the tension of the belt or to change it,
proceed as follows:
1
Switch off the machine via the main on-off switch and
unplug it.
2
Loosen the two screws (T) which hold the brush guard
and wheel in place.
3
Access the lower part of the machine.
Loosen the four nuts (P) so that the motor is unlocked.
4
Turn the screw (M) so that the wheel is loosened and
can thus be changed.
5
Change the belt.
6
Once the belt has been changed, turn the screw again
(M) in the opposite direction in order to tighten the
belt. Then, tighten the four nuts (P) in order to lock
the motor.
Changing the milling cutter
4.2
The milling cutter is changed as follows:
1
Switch off the machine via the main on-off switch and
unplug it.
2
Remove the two screws (J) from the cutter guard and raise
the guard.
When changing the milling cutter: insert the rod in the
3
hole of shaft (A) and release the nut (K) – left hand
thread- in a clockwise direction, using a spanner.
In order to position the new milling cutter, perform the
4
above steps in reverse.
Changing the brush
4.3
Change the brush as follows:
Switch of the machine via the main on-off switch and
1
unplug it.
Loosen the two screws (T), wheel guard and side brush.
2
When changing the brush
Insert rod 7X70 in the hole in the shaft (A) and loosen
3
the screw (K), using an Allen key.
In order to position the new brush, perform the above
4
steps in reverse.
and safety
See figure 13
See figure 14
See figure 15
4.4
Safety recommendations
1
Do not attempt to start up or operate the machine
until all the safety aspects, installation instructions,
operators guide and maintenance procedures have
been followed and understood.
2
Always disconnect the electricity supply before perfor-
ming any cleaning or maintenance.
Always keep the machine and its surrounding area clean.
3
Always work with dry hands.
4
Protective glasses must be worn, even if the machine is
5
equipped with a protector.
6
Make sure that the machine is earthed.
11
Tabla de contenido
