Precautionary Measures - Shark POWER-VAC V900TB Manual Del Usuario

PRECAUTIONARY MEASURES

IMPORTANT: If
the suction opening in
the unit or the hose becomes blocked,
switch off the vacuum cleaner and
remove the blocking substance before
you start the unit again.
1. Do not operate the vacuum
cleaner too close to heaters, or
radiators.
2. Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.
3. Do not vacuum any liquids.
4. Keep hair, loose clothing, fingers,
feet and all parts of body away from
openings.
5. When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.
6.
Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
7. Do not use without HEPA type dust
cup filter in place.
8. Before you start vacuuming,
make sure to remove large or
sharp objects that might damage
the vacuum.
3
OPERATING INSTRUCTIONS
WARNING:
Always unplug from
electrical outlet before opening the
dust cup (container).
NOTE : HEPA type dust cup filter
must be in place when operating the
hand vacuum.
Assembly of Hand Vacuum
1. To open the dust cup (container),
push the dust cup release and pull
out the dust cup (container). (Fig. 1)
Verify that the HEPA type dust cup
filter is inside, then reattach the dust
cup (container) to the hand vacuum.
HEPA Type
Dust Cup
Filter
Fig. 1
2. To use the hand vacuum with the
shoulder strap, attach the strap to
the unit as shown below. (Fig. 2)
Fig. 2
3. To attach the dusting brush, the
crevice tool with brush, or the air driven
turbo brush, to your hand vacuum,
push the desired accessory into the
suction hole. (Fig. 3)
Fig. 3
4. To use the hose with the
accessories, push the narrow end of
the hose into the suction hole, then
attach the desired accessory to the
other end of the hose, as shown
below. (Fig. 4) Please note that
only the narrow end of the hose will
fit into the suction hole.
Fig. 4
How To Operate Your Hand
Vacuum
1. Hold the hand vacuum firmly by
the handle.
2. Push the On/Off power switch to
"On" position.
3. Start vacuuming.
4. Always empty the dust cup after
each use.
5. Tap the HEPA type dust cup filter
on the side of your garbage can to
remove any dust and debris that
adhere to it.
6. Replace the HEPA type dust cup
filter into the dust cup (container)
and reattach the dust cup
(container) to the hand vacuum.
CAUTION:
The hand vacuum is a
very powerful unit. Make sure that you
hold it firmly, otherwise it can slip out of
your hand and cause injury.
4