Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALL SECOND BRACKET.
Match the position of the first bracket.
Measure from edge of bed to the bracket for best results.
Do not tighten second bracket until crossbar is installed.
INSTALL THE CROSSBAR (purchased separately).
If the bar appears to be at an awkward
angle to the rack, loosen the anchor
bolt slightly to permit loading.
CENTER THE BAR.
PERFORM A FINAL TIGHTENING.
TIGHTEN THE
BAR CLAMPS.
CHECK THE INSTALLATION: Lift and pull.
Lift the bar upward.
1033066A-3/12
Tighten the
clamps until the
bar cannot
Tighten again if anything is loose!
rotate.
TIGHTEN THE ANCHOR
Pull the strut from
front to back.
Use the wrench
to loosen the
clamps if needed.
ATTACH END
CAPS.
BOLTS SECURELY.
Tabla de contenido
