Using The Appliance - Bimar PCE1 Manual De Instrucciones

Fax +32 030 9904733

INSTALLATION
• After unpacking, check the integrity of the appliance; if in doubt, do not use and contact a qualified
technician. The packaging materials (plastic bags, polystyrene, metal staples, etc.) must not be left
within reach of children, as they constitute possible sources of danger and must be disposed of
according to applicable regulations.
• Before each use, ensure that the appliance is in good order: if in any doubt, consult a qualified
professional.
• The surface where the appliance is used must be stable, spacious (do not use on shelves), and level
(since the appliance could tip over).
• Ensure that the appliance is kept far from any sources of heat (stoves, heaters), curtains, tapestries,
electrical appliances (such as computers, precision tools, etc.) or delicate furniture that could get
damaged. The surface where the appliance is used must not be damaged should it come into contact
with food.
• Ensure that the appliance works correctly: if not, turn it off and consult a qualified professional.
• When using the appliance for the first time, first clean the bowl: refer to the paragraph "Cleaning
and Maintenance".
• If there is a fault or the appliance is not working correctly, switch it off and have it checked by a
qualified professional. Repairs done by an unqualified person can be dangerous and cause the
guarantee to become void.

USING THE APPLIANCE

The appliance consists of the following parts:
- Base (F), with two slots for batteries and the main ON/OFF switch on the bottom; electronic
panel (L): this allows you to programme the meals, set the time, record and play a command
when the food is dispensed, and it includes a "LO BATT" LED, that lights up when the
batteries need to be replaced.
- Bowl for 4 meals (I): each compartment is numbered (1-4), the
adaptor for commonly-used tins (can be inserted into any
compartment): the bowl is inserted in the base and fits
perfectly only if the grooves "2" match up with the
corresponding notches "1" in the central hole.
- Disc (E), must be inserted in the middle of the hole
- Bowl cover (B) includes the ice compartment (H) and the spring-loaded catch to block the
sliding cover: it has 5 pins that secure it to the base through the corresponding holes set in the
internal ring of the base.
- Sliding cover (C): place it over the open compartment, and hook it onto the spring-loaded catch
(B)
- Main cover (A): closes the cover completely and has 6 pins that secure it to the base through the
corresponding holes set in the external ring of the base.
USING THE APPLIANCE
Ensure the switch is set to OFF
1. Open the 2 covers of the two battery slots, and insert the 4 batteries (2 in each), ensuring the
polarities are correct. The batteries are C type, 1.5V. Replace the battery covers.
2. Set the switch to ON. Text will light up on the display
run for a few seconds
3. Add the food to the compartments, and if you wish to use the tin adaptor ensure that you do not
place too much food in the compartments.
4. Place the cover of the bowl on the base correctly. Insert the disc in the hole in the middle.
5. Place the sliding cover above the uncovered compartment and hook it to cover (B).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
7/24
Assembly page 7/24
, and an auto check cycle will