Bestron ASV45ZR Manual Del Usuario página 27

4. Fit the height lock to the upright.
5. Unscrew the locking ring (2C) from the motor-housing (by turning it counterclockwise) and remove the
ring from the motor housing.
6. Fit the rear of the fan housing (2D) onto the motor-housing, making sure that the openings are aligned
precisely with the lugs on the motor housing and that the grip is at the top.
MONTAGE - Assembling the fan
3
1. Slide the locking ring (2C) onto the shaft, and screw it tight (clockwise).
2. Slide the fan blades (3A) onto the shaft, making sure that the notches are aligned precisely with the two
keys on the shaft.
3. Fit the spinner onto the shaft (3B) and tighten it (anticlockwise) whilst preventing the fan blades from
moving.
4. The rim has five clamps. Carefully fit the rim around the rear half of the fan housing, making sure that
the housing falls into the upper clamp of the rim, so that you can connect the two halfs of the fan housing
with the nut and bolt. Use a crosshead screwdriver to screw the bolt into the nut.
5. Close the other clamps.
OPERATION - Ventilate
1. Connect the plug into an electrical socket and switch on at the wall.
2. Press the "ON/SPEED" button. At first start-up the fan will operate at low speed.
3. Press the same button to choose between Low, Medium and High speed
4. Tilt the fan to the required angle. You can set the fan:
a. to blow horizontally or angled slightly downwards. Tilt the ventilator housing and motor housing to
the required angle.
b. to oscillate from left to right (with a sweep of 75°). This will ventilate much of the room. Press the
oscillation button on the motor housing fully in.
c. remain in the same position whilst the fan is turning. This will ventilate one area. Pull out the
oscillation button until you hear it click.
5. Press the "OFF" button. The fan stops.
OPERATION - Remote control
The appliance can be controlled by use of the control panel, but also with the remote control. For optimal
use:
• The distance between the appliance and the remote control should,nt be more than 6 meters.
• Point the remote control at the appliance and be sure that the angle is smaller than 30 degrees.
1. Press the "ON/SPEED" button. At first start-up the fan will operate at low speed.
2. Press the same button to choose between Low, Medium and High speed
3. Press the "OFF" button. The fan stops.
B
A
27
(low, mid, high).
(low, mid, high).
EN