Star Progetti HELIOS RADIANT BLACK Instrucciones De Uso página 11

Do not place the heater immediately under a power socket.
To get the best heating performance, the ideal positioning of the appliance is 45° inclined
downwards, and the appliance to be fixed perfectly horizontal.
4. POSITIONING HELIOS BLACK
• Adjust the HELIOS BLACK reflector in the direction of the required heating bundle, when
installing on a wall. It is usually a 45° inclination related to the horizontal line.
• The appliance must never be installed on a flammable surface, HELIOS BLACK must be
placed at a safe distance (clear space) of minimum 2.0 m. from combustible materials such
as: cartons, fabrics, curtains etc. as well as glass walls.
• If placed in workshops and garages where there are flammable paints and liquids, HELIOS
BLACK must be placed at a
• minimum distance of 4 m. from the source of danger.
• We suggest not to use HELIOS BLACK in particularly dusty and closed areas. This could
damage the bulb.
• When mounting inside a bathroom, always respect the minimum distances from showers
and baths, and ensure compliance with CEE-CEI.
• Furthermore, the commands to adjust the appliance and turn it on and off must not be
within reach of the shower or bath.
5. CLEANING
The cover and bulb must be kept clean to maintain the heater's original heat efficiency. Use only
denatured alcohol and a clean cloth. Other products may damage the heater.
6. INSTRUCTIONS FOR REPLACING THE BULB
WARNING - The HELIOS BLACK guarantee does not cover replacement or repair of the bulb. To
change the bulb contact a professionally qualified electrician or assistance service.
BEFORE PROCEEDING WITH BULB REPLACEMENT, OPERATORS MUST:
FULLY DISCONNECT THE DEVICE FROM POWER SUPPLY AND MAKE SURE THE BULB IS COLD
1.
NOT TOUCH THE BULB WITH THEIR BARE HANDS.
2.
To maintain the heating efficiency of your HELIOS BLACK, occasionally dust the cover and bulb
with a clean brush or compressed air.
To replace the bulb:
1) Disconnect the heater from the power supply
2) Loosen and remove the frame fixing screws
3) Remove the frame
4) Remove the cover, which does not have internal fixing points.
5) Remove the bulb by expanding the locking spring and sliding it out.
6) Disconnect the bulb wires from the two (2) terminals.
7) Insert the new bulb, reconnect the wires and fit the locking spring, taking care not to touch the
bulb with bare hands .
8) o close HELIOS BLACK, replace the cover, frame and screws.
If necessary, call our Technical Service. Technical Office tel. 02/90639261
11