Preparing For Measurement; Inserting/Changing Batteries; Setting Date And Time - innohaus ABC 30 Manual De Instrucciones

6. Preparing for Measurement

Inserting/changing batteries:

1. Remove
the Battery
Compartment
Cover on the
left side of the
device.
2. Insert two 1.5 V 'AAA' alkaline batteries
(included) according to the polarity markings
inside the compartment.
NOTE: Do not use other types of batteries.
3. Reattach the Battery Compartment Cover.
4. Before first use, remove the clear plastic film
from the LCD Display.
If the battery change symbol
displayed, no further measurements are possible
and you must replace all batteries. Once batteries
have been removed from the device, the date and
time must be reset. Memories (if any) will not be
deleted during battery replacement.

Setting date and time:

You should set the date and time without fail.
Otherwise, you will not be able to save your
measured values correctly with a date and time
and access them again later. The time is displayed
in the 12-hour format.
To set the date and time, proceed as follows:
1. After inserting the batteries:
• Following the display check, during which all seg-
ments appear, the year flashes on the display.
• U sing the +/M button, you can increase the
basic values to be set. Set the year and confirm
the entry using the
• N ow set the month using the +/M button. Con-
firm using the
• S et the day/hour/minute and confirm each
is continuously
using the
• To switch off, press the START/STOP button
2. At any time:
• P ress the
and current user memory.
18
button.
button.
button.
button to display the date/time
.