Tips And Hints - Dörr SNAPSHOT MINI BLACK 12MP HD Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Move with normal speed through detection area. The camera triggers now.
You can view the image on the monitor as described in chapter 07.19 Playback . The camera should be oriented in a way that the
object will appear in the centre of the picture. You may have to re-adjust the camera and take another test shot.
Tip
To change the camera angle you can use e.g. a small wooden wedge between camera and trunk.
Once the camera position is correct, the fixing belt can be tightened to hold the camera firmly.
Switch off the camera after test shooting (09 = OFF).
10 | START SURVEILLANCE
In order to get the camera ready to work, move the slide control (09) to the position ON. Then close the camera housing. After approx.
5 seconds, the camera will be active. In case of movements detected, it takes pictures according to your settings.
11 | CAMERA CHECK UP
There are various possibilities to check if images have been taken:
Open the camera and switch it off (09 = OFF). After 2 seconds switch the slide control (09) to SETUP mode. On the LCD display
1.
(08) you can see the starting image. The bottom line shows how many pictures have been taken and how many more will fit on
the SD card e.g. [00034/1846m]. Press the OK button (12) to view the images on the LCD display (08).
2.
Alternatively, you can view the images comfortably on your home PC using an image viewer.
CAUTION:
To avoid camera damages always make sure that camera is switched off (09=OFF) before removing SD card!
When checking the camera function, also check battery status. If the batteries are no longer providing sufficient power, there
3.
may be deficiencies with the quality of the pictures, especially with nightly shots since the flash requires more energy than
available. In case of doubt, exchange the batteries.

12 | TIPS AND HINTS

SD MEMORY CARD
The camera only works with an SD memory card. There are SD cards which may not work with the DÖRR SnapShot and may affect
the function of the camera. Usually it helps to use another SD card of other brand or different capacity. We recommend using a SD
card with a capacity of 4GB up to max. 32GB (optionally available from DÖRR).
LENS RATTLES
The camera lens is covered with a filter which allows coloured pictures at daylight and black & white shots at night. When camera is
turned off the filter is not fixed which can cause the rattle noise. However, this is no defect.
WEATHER PROTECTION
Although the camera is weatherproof and well-suited for outdoor use, we recommend mounting it at a secured place, so not on the
weather side or in the direct sunshine. After long periods of humidity, caused by rain or fog, the camera should be stored in a dry area
for a few days. Dust and splash waterproof according to protection class IP54.
23
doerr-outdoor.de
Tabla de contenido
loading

Tabla de contenido