Troubleshooting; Parts List - Metalworks CAT 210 Manual De Instrucciones

CAT210 - NLFRENES - v2.0 - 16072013
EN

6 Troubleshooting

Problem
Excessive dust in the cabinet
Uneven blasting actions
Inadequate speed or inefficiency of
blast
Static electricity

7 Parts list

Cause
Exhaust vent plugged or air flow is
blocked.
Abrasive media worn.
Too much abrasive media inside
cabinet.
Loose air line or fitting connections.
Too much abrasive media inside
cabinet.
Moisture present inside the cabinet.
Abrasive media worn.
Pressure too low.
Dry weather conditions.
Remedy
Clean rear vent and keep vent away
from any wall.
Replace abrasive media.
Remove excess media.
Tighten fitting and make sure air lines
are secure.
Remove excess media.
Check air line to make sure there is no
moisture in it.
Replace abrasive media.
Increase inlet pressure and make sure
control valve is fully opened.
Leave the item being cleaned on the
grating.
®
13