GBC ClassicCut CL200 Manual De Instrucciones página 5

Laser Light
E. Before use, insert the batteries provided (2 x AAA -
1
1.5v) into the battery compartment located below the
carry handle.
2 Laser Light Alignment
B. The laser-cutting guide may become out of alignment
with the cutting edge. Follow these instructions for the re-
alignment process.
• Use the Allen key (M3) included with your trimmer. Insert
the key into hole A and into the Allen screw. By turning
the screw clockwise, the entire length of the laser beam
move to the right. By turning the screw anti-clockwise,
the entire length of the laser beam will move to the left
(see graphics).
• Using the Allen key, insert the key into hole B and into the
Allen screw. By turning the screw clockwise, the bottom
angle of the laser beam will move to the left. By turning
the screw anti-clockwise, the bottom angle of the laser
beam will move to the right (see graphics).
Cutting Restrictions
• Remove staples, paper clips etc. before cutting.
• Do not cut metal film, film containing glass etc.
• Do not cut more sheets than cutting capacity allows.
• Do not carry guillotine by holding on to the cutting
blade or the cutting arm.
• Always operate guillotine with both hands and on a stable
base or desk.
• Check the fittings of the blade and safety cutting guard from
time to time.
Guarantee
Operation of this machine is guaranteed for two years from
date of purchase, subject to normal use. Within the guarantee
period, GBC will at its own discretion either repair or replace
the defective machine free of charge. Defects due to misuse
or use for inappropriate purposes are not covered under the
guarantee. Proof of date of purchase will be required. Repairs
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 96333500
CL410/
Operating the Guillotine
CL420
Place the guillotine on a stable, flat surface such as a table.
1
Unlock the safety cutting arm latch (5) and lift cutting arm
2
into cutting position.
C1. CL200/CL410: With the left hand, place your paper in
3
the desired position. Use your left hand to press down the
paper clamp.
C2. CL420: Place the paper under the Heavy Duty Paper
clamp as well as the Safety Guard. Adjust the paper
according to the cutting desired. Hold the sheets securely
into place and press the paper Clamp handle down to lock
it. To unlock paper clamp, lift the handle back up.
D. CL410/CL420: To switch on the Laser light, simply press
4
down the laser button located on the upper side of the
guillotine. The laser light will provide a straight line,
indicating the exact cutting position. After use, you can
switch off the laser light, however it will automatically turn
itself off after 4-10 minutes, by gradually fading. To obtain
a brighter line, switch off the laserlight and turn it on again.
In addition to the laser light, use the grid and Paper Guides
5
to ensure precise cut.
When finished with the guillotine, always place the
6
cutting arm in the down position and secure the handle
safety latch.
Located on the top of the machine, the carry handle (8)
7
makes it easier for you to move your guillotine.
Service
Do not attempt to service or repair the unit yourself. If your
guillotine is under warranty return it to the point of purchase
for replacement or repair. If your guillotine is no longer under
the point of purchase return period and requires replacement
or repair, please contact your supplier for further assistance.
or alterations made by persons not authorised by GBC will
invalidate the guarantee. It is our aim to ensure that our
products perform to the specifications stated. This guarantee
does not affect the legal rights which consumers have under
applicable national legislation governing the sale of goods.
5