Idiomas disponibles
Idiomas disponibles
FAILURE TO OBSERVE THESE WARNINGS
this instruction manual contains important
safety information.
reAd this instruction mAnuAl cArefully
And understAnd All informAtion before
operAting this tool.
• Always operate, inspect and maintain this
tool
National
Code
B186.1) and any other applicable safety
codes and regulations.
• For safety, top performance and maximum
durability of parts, operate this tool at 90
psig; 6.2 bar max air pressure with 5/16"
diameter air supply hose.
• Always wear impact-resistant eye and face
protection when operating or performing
maintenance on this tool.
• Always wear hearing protection when using
this tool. High sound levels can cause
permanent hearing loss. Use hearing
protection as recommended by your
employer or OSHA regulation.
• Keep the tool in efficient operating
condition.
• Operators and maintenance personnel
must be physically able to handle the bulk,
weight and power of this tool.
• Compressed air can cause severe injury.
Never direct air at yourself or others.
Always turn off the air supply, drain
hose of air pressure and detach tool
from air supply before installing, removing
or adjusting any accessory on this tool,
or before performing any maintenance
on this tool. Failure to do so could result
in injury. Whip hoses can cause serious
injury. Always check for damaged, frayed or
loose hoses and fittings, and replace
immediately. Do not use quick detach
couplings at tool. See instructions for correct
set-up.
• Air powered tools can vibrate during use.
Vibration, repetitive motions or uncomfortable
positions over extended periods of time may
be harmful to your hands and arms.
Discontinue use of tool if discomfort, tingling
feeling or pain occurs. Seek medical advice
before resuming use.
SX1000
COULD RESULT IN INJURY
in
accordance
with
American
Standards
Institute
of
Portable
Air
Tools
Safety
(ANSI
• Place the tool on the work before starting
the tool. Do not point or indulge in any
horseplay with this tool.
• Slipping, tripping and/or falling while
operating air tools can be a major cause
of serious injury or death. Be aware of
excess hose left on the walking or
work surface.
• Keep body working stance balanced and
firm. Do not overreach when operating
the tool.
• Anticipate and be alert for sudden changes
in motion during start up and operation
of any power tool.
• Do not carry tool by the hose. Protect the
hose from sharp objects and heat.
• Tool shaft may continue to rotate briefly
after throttle is released.
contact with accessories during and after
use. Gloves will reduce the risk of cuts
or burns.
• Keep away from rotating end of tool. Do not
wear jewelry or loose clothing. Secure long
hair. Scalping can occur if hair is not kept
away from tool and accessories. Choking
can occur if neckwear is not kept away from
tool and accessories.
• Do not use near flammable materials, such as
gas tanks.
• Do not vacuum any liquids.
• Take care that the exhaust air does not
point towards any other person or material
or substance that could be contaminated
by oil droplets. When first lubricating a tool
or if the tool exhaust has a high oil content
do not allow the exhaust air to come near very
hot surfaces or flames.
• This tool is not suitable for underwater use
or use in explosive environments.
• Do not lubricate tools with flammable or
volatile liquids such as kerosene, diesel or
jet fuel.
• Do not force tool beyond its rated capacity.
• Do not remove any labels. Replace damaged
labels.
• Use
accessories
recommended
®
Sunex Tools
.
Avoid direct
by
01/18/08
