Virax 294121 Manual De Instrucciones página 12

3.3 Removing or inserting the batteries of the 16 m CABLE for Mini VISIOVAL
In order to reduce the risk of severe injuries during use, follow the assembly procedures.
To remove or insert the batteries of the 16 m CABLE for Mini VISIOVAL
NOTE: Do not forget to read the batteries information before inserting them.
1. Check that the battery compartment lid is free from debris and liquid. Use a Phillips head
screwdriver to remove the screw of the battery compartment lid (Figure 1)
2. To remove the batteries, tilt the base slightly to ease the batteries into your hand.
3. Make sure that the polarity is correct and insert the 2 AA batteries. Replace the lid and the
screw.
3.4 Connection of the 16 m CABLE to the Mini VISIOVAL
Only one device can be connected to the mini VISIOVAL at a time. Always ensure that
the device is turned off when you install or remove an imager or other accessory.
In order to use the 16 m CABLE for the Mini VISIOVAL, the CABLE plug must be plugged into the
Mini VISIOVAL camera's slot.
To connect the CABLE to the camera, ensure that the plug and the slot (Figure 2) are properly
aligned. Once connected, fasten the knurled nut by hand to secure the connection.
Figure 2 - Cable connections (Connector type A Color Black).
(NOTE) Identical for the Mini VISIOVAL inspection camera and for the 16 m CABLE for Mini
VISIOVAL.
12
Figure 1 – 16 m cable for Mini VISIOVAL
Slot
Plug
EN