Product Use; Bevel Sanding - Greencut LJ400C Manual De Instrucciones

56
ALIGNING THE WORK TABLE WITH THE SANDING DISC
1. Disconnect the machine from the mains.
2. Using a combination of brackets, check the angle of the
work table to the face of the sanding disc.
3. If the work table is not 90° from the disc, loosen the table
locking knob and tilt it so that it is square with the disc.
4. Retighten the table lock knob.

PRODUCT USE

ATTENTION: Always make sure that the workpiece is not in contact with the belt/disk before
starting the machine.
In the event of a power failure, turn off the machine to prevent it from starting when the power
returns.
IGNITED
1. To turn on the machine, press the green ON ("I") button.
2. To switch off the machine: Press the red OFF ("O") key.

BEVEL SANDING

The work table can be tilted from 0° to 45° for bevel sanding. For angles from 30°, position the machine close to the
edge of the workbench so that the work table can rotate completely.
Tilt the work table:
1. Loosen the locking knob on the work table by turning it to the left (counterclockwise).
2. Rotate the work table to the desired angle.
3. Tighten the locking knob on the work table by turning it clockwise.
Table lock knob
Table lock knob
Combination bracket