Selecting Opening Direction - entrematic Ditec QIK4E-7EH-7YEH Manual De Instalación

10. Selecting opening direction

QIKM1 (grey)
QIKM2 (green)
QIKM3 (red Ø38)
QIKM4 (red Ø51)
- Select the opening direction as shown in the figure.
- Mount the spring using the special screw M12x40 [C] with thread locking compound and tightly
fasten as shown in the figure.
- [QIK4E] Set the DIP2 on the control panel E1A as shown in the figure.
[QIK7EH] Set the DIP2A on the control panel EL31R as shown in the figure.
- Once you have installed the bar, adjust spring compression using the nuts [B] until measure-
ment A in the table is obtained.
A
≥ 190 mm
≥ 190 mm
≥ 220 mm
≥ 220 mm
Right opening
DIP2=OFF [E1A]
DIP2A=OFF [EL31R]
C
B
35
Left opening
DIP2=ON [E1A]
DIP2A=ON [EL31R]
85 Nm