Assembly - Triton WCA390 Instrucciones De Uso

unattended. Such preventative safety
measures reduce the risk of starting the
power tool accidentally by untrained users.
f. Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tools operation. If damaged, have
the power tool repaired before use. Many
accidents are caused by poorly maintained
power tools.
g. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
h. Use the power tool, accessories and tool bits
etc., in accordance with these instructions and

ASSEMBLY

Assembly
Release the clamp knobs and remove the saw
from the chassis. Place the chassis upside
down on a flat working surface.
Step 1
Using a Phillips-head screwdriver remove the
steel bolt and two sets of bearings (with red
spacers) from the rear of the chassis. Retain
the M4 screws and flange nuts for use in Step
4. Fit the bearings (O) (without their red plastic
spacers) to the U-frame (A), using the
⁄ " Phillips-head screws (J) supplied.
7
8
Step 2
Loosen the two bearings at the front of the
chassis and rotate them 180° (with the
locating tabs pointing the opposite way).
Re-tighten.
Step 3
Fit the U-frame (tabs upwards) to the slide
chassis using the M6 x 16mm Phillips-head
screws (L) and 6 washers (K). Note that the
chassis and U-frame are spaced apart by two
washers on each side. Do not over tighten.
Step 4
Attach the bracket on the winder assembly (B)
on the inside of the U-shaped cut-out at the
rear of the chassis using the three M4 x 10mm
Phillips-head screws retained from Step 1.
in the manner intended for the particular type
of power tool, taking into account the working
conditions and the work to be performed. Use
of the power tool for operations different from
those intended could result in a hazardous
situation.
5. Service
a. Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
Step 5
Attach the U-frame to the winder assembly by
fastening the top saddle (D) into position using
the M4 x 30mm Phillips-head screws (G), M4
x 25mm Phillips-head screw (H) and nyloc
nuts (I). Fully tighten the three longer screws,
but only tighten the shorter screw to a point
where the saddle is firm yet still free to pivot
on the tube.
Step 6
⁄ " x Snap the appropriate chassis hook (E or F
3
16
depending on your Workcentre) on the tube of
the U-frame, as shown.
Step 7
Clamp the saw back into the chassis and
fit the chassis to the Workcentre in the rip
position. Slide the chassis half-way along
the bearing channels and while lowering
the tabletop ensure that the rear brace on
the underside of the table locates in the
chassis hook. You may need to slide the hook
sideways along the tube until it is clear of any
table protrusions. Mark the bearing channels
at this location to aid in future set-ups. Lock
down the tabletop.
General Safety Instructions / Assembly
GB
5