Selecting The Unit Of Measurement (Cm/M); Using The Digital Laser Tape Measure - Kompernaß KH3259 Instrucciones De Uso

Cinta métrica láser digital
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Selecting the unit of measurement (cm/m)

Press and hold, with a switched on digital display
until the measurement unit „m" (Meter) is shown in the digital
display
4
.
To return to the measurement unit „cm" (centimeter), press and
hold the button
Note:
When switching the appliance on, the last used measurement
unit appears in the digital display

Using the Digital Laser Tape Measure

Press the release button
tape
2
with greater ease. When you let go of it, the measuring
tape is locked. When it is pressed again, the measuring tape is
once more free to move, e.g. for automatic retraction or to be
pulled further out.
If you switched the digital display
this will show the distance between the leading edge of the appliance
and the indentation
digital display
show the error message „Err".
Use the water glasses
appliance. When the air bubbles are between the markings,
the appliance is lined up horizontally on all sides.
Using the Laser Marking Function
Press once on the button
Place the laser against the desired wall and align it for vertical
line marking with the help of the water glasses
5
once again.
6
to be able to withdraw the measuring
1
on the measuring tape. If you first switch the
4
on during or after pulling out the tape, it will then
3
to utilise the spirit level function in the
5
to switch the laser on.
- 26 -
4
.
4
4
on before pulling out the tape,
3
.
, the button
5
,
Tabla de contenido
loading

Tabla de contenido