Reverse The Door - Beper 90.002 Manual De Instrucciones

EN
Thermoelectric refrigerator Use instructions
12. Do not use the appliance near inflammable objects.
13. Do not place objects in the slots of the appliance.
DESCRIPTION OF THE ITEM Fig. 1
1. Temperature Adjustor
2.Light
3 Fan mask
4. Shelf
5. Grid grooves
6. Foot
7. Condensate collection tray
8. Ream cover
9. Opening handle
10. Compartment
11. Bottles compartment
12. Sealing gasket
13. Door
14. Power cord
FRIDGE SETTING
Remove all packing material and accessories. Examine the fridge to see that there are no damages. Do not
install the fridge if damaged.
Place on a flat surface that provides enough space for ventilation. Leave a minimum free space of 5 cm for the
sides of the fridge and 10 cm for the back side.
The fridge is not designed for recessed use, because it needs to keep proper ventilation on its parts.
The fridge should not be used close to sources that produce heat or cold.
Do not climb over the fridge, avoid the bumps.
Do not use the fridge as a holder for objects or containers.
Do not open the fridge door frequently, especially when it is very hot; in any case close the door after a short
time after opening.
Do not use the fridge, exposing it to dangerous atmospheres due to its integrity, such as rain, wind, excess
moisture, chemicals, gas, sunlight, etc.
Do not introduce food or drinks that are too hot inside the refrigerator.
If the food or drinks extracted from the fridge have odor or strange color, it is advisable not to consume them,
they are probably out of date.
We recommend installing the fridge in a place where the temperature is between 10-26 ° C. If the room tempera-
ture is higher or lower than the recommended one, the performance of the appliance may be affected.
Climate class SN: room temperature + 10 ° C to + 32 ° C
Climate class N: room temperature from + 16 ° C to + 32 ° C

REVERSE THE DOOR

The fridge was assembled with the front door open from left to right. Fig.2
The door brackets are located on the right side of the fridge. Fig.3
If you want to change the way the door is opened, follow the steps below.
Empty the inside of the fridge completely from any food or drink. Disconnect the power cord from the electrical
outlet.
Two screwdrivers are needed, one with a cross head and one with a thin flat head.
Remove the upper and lower covers of the brackets using the flat head screwdriver, inserting it into the grooves
to lift them.
Using the cross-head screwdriver unscrew all the screws that hold the brackets securely and remove them. Be
careful not to drop the front door when it is disconnected.
1 - Do not overturn the fridge to remove the lower bracket.
2 - Replace the brackets on the other side of the fridge, securely fastening the screws and reinserting the covers
on the brackets. Fig.4
11