Control Panel; System Configurations - Vonyx SPS122 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

CONTROL PANEL

OPERATION:
Connect the passive speaker with the supplied speaker cable to the speaker output connector (8). WARNING: only
connected the original slave speaker on the speaker output terminal!
LINE INPUT (DVD, CD-player etc.): Connect the source (DVD-player, CD-player etc.) to the line input (10).
MICROPHONE: Inset the microphone to the MIC Jack or MIC XLR socket (11)
POWER: Connect the device with an electric outlet (220-240VAC / 50Hz)
Adjust the master VOLUME (8) and the line (4), mic (5) level to get the right sound balance.
Adjust the tone control (2+3) to get the right sound.

SYSTEM CONFIGURATIONS

SPECIFICATION
Output power: ...................... 700W (2x 350W Max)
Frequency Response: ....................... 50Hz - 20kHz
SPL max: ....................................................... 122dB
Woofer: ............................................................... 12"
1. Volume control for the output
2. Treble tone control
3. Bass tone control
4. Volume control for the line input
5. Volume control for the microphone
6. Clip indication. These LED will light up when amplifier are
max power. It can occur that these LED will lit up now and then, this
is not a problem. But if it lights up continually you need to adjust the
volume down, otherwise permanent damage to equipment might
occur
7. Power Indication. This clear green indicator will light when the
amplifier is turned on.
8. Speaker output
9. Output connector (line out). For connection to a second active
speaker box.
10. Line input for audio input source e.g. mixer, CD player, etc
11. Microphone input
12. On/Off Switch: For switching the speaker on and off. Always adjust
the volume down to its minimum before switching this speaker on.
13. Mains Power Connector / Fuse. This main fuse secures the
speaker against defects. Replace this only with a fuse of same
type and value.
Horn: ........................................... 1" Piezo Tweeter
Power supply: ........................ 220~240VAC / 50Hz
Dimension: ..................... 120 x 38 x 38cm (1 piece)
Weight per set: ................................................. 29kg
on
3
Tabla de contenido
loading

Este manual también es adecuado para:

170.300

Tabla de contenido