GB Intsruments Wire-Tracker GET-4110K Manual De Instrucciones página 3

Receiver
The receiver can be placed in the
front slot of the transmitter for easy
storage. The unit contains an On/Off
button on the top, located behind the
sensitivity wheel. To activate the
receiver, press and hold this button.
The unit is now locating the signal.
Bring the unit near the wire being
traced. If this is the correct wire, an
audible "warbling" tone will be heard,
and the LED will increase in
brightness. Use the sensitivity wheel
to adjust the sensing range.
Tracing Wiring
Electric Shock Hazard.
WARNING WARNING
!
Trace only unenergized wiring.
Contact with live circuits can
result in severe injury or death.
Always disconnect power to the
circuit prior to using the
Wire Tracker or LAN Tracker.
Open the back of the transmitter and
select the appropriate plug or clip for
the wiring being traced.
3
Fold the plug or clip out and close
the housing door. Connect the
transmitter to the wiring and press
the On/Off button to activate.
Activate the receiver by depressing
the On/Off button and continuing to
hold down. Bring the receiver near
the transmitter and check for the
audible and visual signals. This
verifies that both units are functioning
properly. Trace wiring by following the
audible and visual signals that the
receiver is producing.
Tracing Telephone Wiring
To prevent interference, disconnect
the house line from the main
telephone company service. This can
be done by locating the junction box
where the house is connected to the
telephone company wiring. Remove
any connections from the house to
this box, making sure to note the
proper location of each wire for later
reconnection. Use the RJ-11
(telephone) plug for insertion into a
standard telephone jack. Trace the
wiring as described above.
4