Cleaning And Maintenance - Mx Onda MX-EZ2230 Manual De Instrucciones

Hold the pressure lever by the handle and lower it gently over the citric,
increasing the lever pressure gradually.
The engine will automatically spin and begin to extract the juice from the
fruit.
When you stop pressing the lever on the citric, the engine will stop and
remain in the idle state.
When the work is finished, unplug the juicer from the mains.
Set the direct discharge outlet up until you hear a "click" and you can
remove the container without dripping.
Attention:
 When you want to squeeze out a lot of citrus, you should often pull out the
strainer and remove excess stored pulp.
 Remember that the capacity of the container is 400 milliliters, be careful
not to exceed the capacity of it.

CLEANING AND MAINTENANCE

To prevent electrocution, before cleaning the juicer, disconnect it from the
mains.
Do not wipe the base of the juicer with water or soak it.
Plastic and metal surfaces can be wiped with a damp cloth, do not use
abrasives.
Dry pulp is difficult to remove, so it is recommended that immediately after
use, clean the different parts of your juicer.
Do not insert the elements that make up the juicer (cones, strainer,
transparent container or the juicer body) into the dishwasher.
For ease of cleaning the motor shaft, container, strainer and cones can be
removed. Once these parts are clean and completely dry, reassemble
them.
Once the juicer has been cleaned and dried, you can pick up the cord at
the base of the juicer if you wish.
7