Idiomas disponibles
Idiomas disponibles
www.siliceo.es
SILICEO ONLINE
MALENT DDT40 5180LM Cree XM L2 Waterproof 4 Modes LED Flashlight
English User Manual:
Product Description
The Imalent DDT40 is a multi-functional touchscreen floodlight with a built-in digital compass,
temperature sensor & remote control capabilities in 1 light. It comes with 4 spot Cree XM-L2s at
the front outputting 4000 lumens along with 2 more Cree XP-Ls LED at the sides that give 360
degree lighting that outputs 1,180 lumens. This is the craziest light from Imalent that we have
seen. Uses 4 x 18650 batteries with a powerful beam that goes up to 450 meters.
Imalent's 'Shark Series' model DDT40, multi-functional touch screen controlled and remote
controlled flashlight, utilizes 6 LEDs to offer a broad range of illumination options and power
display function. Output up to 5180lumens creates intense area lighting combined with long
reach. Idea for group leaders needing high output and multiple beam patterns, the DDT40 is a
powerful addition to a team's onsite lighting tools with instant high, strobe and SOS.
Operations:
1. Battery installation
Unscrew the tail cap. Insert 4pcs 18650 rechargeable Li-ion batteries or 8pcs CR123A (3.0V)
batteries into the flashlight with the positive (+) towards the head. Replace the battery tube.
2. OLED Screen
When the DDT40 is turned on, the OLED display will activate automatically and show lumen
output, battery voltage, battery status, compass and approximate temperature. After displaying
this information will remain on lumen output and 30 seconds later the OLED display will turn off
automatically if without action on the right mode switch. The display can be reactivated by
pressing the small right mode button.
3. Mode transfer
With the spot light on, softly press the left mode button to transfer between spot and flood
light; press and hold the button for more than 0.3 seconds each time to enter strobe - beacon -
SOS, softly press the left mode button again to quit special mode (include strobe, beacon and
SOS).
4. Brightness selection
Insert batteries, press power switch one time, will get turbo output, the flashlight will change to
high output automatically 3 minutes later to protect circuit and LED. With the light on (spot or
flood), press and hold the upper button '+' on the top of the touch screen, the brightness will
increase itself, while press and hold the bottom button '-' on the touch screen, the brightness
will decrease itself, release your finger at any output you need, will save it.
5. Remote control operation
With the light on, put the remote controller towards any receiver on both sides of the flashlight
head, press power switch on the remote controller to turn on and turn off the light, pressing
mode button to transfer the light from main spot light to flood light to red light, press button to
