Technical Data; Ce Mark And Ec Conformity - RADEMACHER 2540 06 36 Instrucciones De Montaje

i

Technical Data

Motor series:
Type:
i
Setting parameters on EIB/KNX shutter actuators for RADEMACHER tubular motors
The following parameters must be adjusted before commissioning to ensure the smooth
operation of RADEMACHER tubular motors with EIB/KNX shutter actuators:
Short-term operation
Where possible, short-term (slat adjustment) operation must be turned off.
E.g. short-term operating mode
Time: = 0 ms
i

CE Mark and EC Conformity

Tubular motors of series RolloTube Comfort Small and Medium (item numbers.:
2540 06 36 / 2540 10 36 / 2560 10 96 / 2560 20 96 / 2560 30 96 / 2560 40 96)
complies with the requirements of the current European and national directives:
2006/42/EC
2014/30/EU
Conformity has been verified. The corresponding declarations and documentation are available
on file at the manufacturer's premises.
RADEMACHER Geräte-Elektronik GmbH
Buschkamp 7
46414 Rhede (Germany)
Small
6/28 10/16 10/16 20/16
6 10 10 20
28
16 16 16
230 230 230 230
50 50 50 50
121 121 112 145
0.53 0.53 0.49 0.64
4
4 4 4
5 5 5 5
0.75 0.75 0.75 0.75
3
3 3 3
32 32 32 32
H H H H
I
I I
IP 44 IP 44 IP 44 IP 44
PVC PVC PVC PVC
462 462 465 465
35 35 45 45
3
3 2 2
≤ 70
≤ 70 ≤ 70 ≤ 70
Machinery directive
EMC directive
Medium
30/16 40/16
30 40 Nm
rpm
16 16
230 230 V
50 50 Hz
191 198 W
0.83 0.86 A
Min.
4 4
5 5
0.75 0.75 mm
2
m
3 3
32 32 R
H H
I I I
IP 44 IP 44
PVC PVC
524 524 mm
45 45 mm
2 2
dB(A)
≤ 70 ≤ 70
If your software application does not support turning off short-term
operation...
...you must ensure that the time between short-term and long-term operation specified
for the touch sensor is shorter than the time between short-term and long-term operation
specified for the actuator.
This prevents the actuator from suddenly switching off when the sensor button is pressed.
Long-term operation
The motor must be de-energized at the latest after 180 seconds.
E.g. Basis for long-term operation
Basis:
Factor: = 86
Nominal torque:
Idle speed:
Rated voltage:
Frequency:
Nominal output:
Current consumption:
Operating time:
Number of cable cores:
Wire cross-section:
Cable length (standard):
Limit switch range (number of revolutions):
Insulation class:
Protection class:
Protection type in accordance with VDE 700:
Type of cable:
Length of motor witout bearing:
Pipe diameter:
Number of parallel switchable tubular motors
(in case of using a RADEMACHER control, e.g. Troll Comfort)
Noise pressure level (LpA):
= 2.1 s
= (2.1 s x 86 = 180.6 s)
EN
57