Mounting Instructions - HQ CHAR-CAR05 Manual De Uso

1. LED charge status display shows "power", "charging" and "fully charged"
2. Switch on/off
3. Thermostatically controlled cooling fan
4. 5.0mm Mounting hole
5. Mounting flange
6. Power on LED
7. Fault LED
8. Power cord
9. DC leads

Mounting instructions

INDOOR USE ONLY
3.5mm Mounting hole
Min 10 CM
Permanent wiring to battery
It is possible to hard wire the DC charging leads to the battery for permanent installations. You will
need 2 x ring terminals, an inline fuse holder and a fuse with a rating equal to or more than twice that
of the chargers output (see below).
5 A = 10 Amp fuse
10 A = 20 Amp fuse
20 A = 40 Amp fuse
Connection:
Cut off the supplied battery clips; ensure you leave sufficient cable to reach the battery terminals.
(DO NOT stretch the battery charger DC cables).
Bad
Good
3