Duraflame 10QI071ARA Manual De Instrucciones página 6

Ocultar thumbs Ver también para 10QI071ARA:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS CONTROL FUNCTIONS
TO ACCESS CONTROL PANEL-
Control panel can be accessed on the front panel of the heater.
Model#
10QI071ARA
- POWER
1. a. The power button supplies power to all the
functions of the heater.
b. The power button will turn on the heat function
to the ON position.
c. The power button on the remote control will put the
heater in standby mode. This will turn off all
functions and hold the settings in the memory. By
pressing the POWER button again the unit will turn
on to the same settings except the timer function.
2. Pressing and holding the POWER button on the control
panel for 3 seconds will switch between °F and °C.
- TIMER
1. a. There are 9 timer settings and OFF that can be selected.
OFF(00), 30min, 1Hour, 2H, 3H, 4H, 5H, 6H, 7H, 8H.
b. Double-digit minute settings, such as:
30 minutes are:
c. A digital plus a "H" show hours setting, such as:
2 Hours are:
2. If the timer function was previously set the first press
of the timer button won't change the previous setting.
Pressing the timer button will activate the timer display.
3. When the timer is active, the LCD display will count
down from 60 seconds before shutting off the heater.
4. To cancel the timer function at any time, press and hold
the timer button for 3 seconds and the LCD display
will show:
▲ ▼- SETTING TEMPERATURE
1. When pressing the ▲ ▼ buttons the LCD display will enter temperature setting mode.
2. When in temperature setting mode pressing the ▲ ▼ buttons will change the thermostat by 1 °F (1 °C.)
The temperature setting range is between 50 °F - 97 °F (10 °C and 36 °C).
3. The default temperature is 72 °F (22 °C.)
4. After 5 seconds of no control input the LCD display will exit temperature setting mode and display the
current setting temperature.
NOTE: After the heater function or power is shutoff the blower will continue to run for several minutes to cool
the internal components.
LCD SCREEN BRIGHTNESS ADJUSTMENT
By default the LCD display is on the brightest setting. To adjust the brightness, press the TIMER button
one time then use the ▲ ▼ buttons to increase or decrease the screen brightness.
Figure 4
E-5
Figure 5
NOTE: PLEASE OPERATE REMOTE
TRANSMITTER AT A SLOW MEASURED
PACE. PRESS THE REMOTE CONTROL
BUTTONS WITH AN EVEN MOTION
AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID
SUCCESSION MAY CAUSE THE
TRANSMITTER TO MALFUNCTION.
Tabla de contenido
loading

Tabla de contenido