Troubleshooting - ECG CDR 888 USB Manual De Instrucciones

Disc storage
Do not store discs in places exposed to direct sunlight or near a heat source.
Do not store discs in locations exposed to dust and moisture, such as a bathroom or near a humidifi er.
Storing discs vertically in a box, laying the discs on each other or placing foreign objects on unboxed discs can
cause their deformation.
Cleaning the tape player
Use cotton swabs dipped in alcohol or special cleaning solution for
cleaning tape heads.
1. Press to open the door of the cassette tape compartment.
2. Press and clean the rubber pressure roller (A).
3. Press and clean the magnetic heads (C) and axle (B).
4. Press after cleaning.
Note:
Tape recorder can also be cleaned with a special cleaning cassette.

TROUBLESHOOTING

Problems may often be caused by some small things. The following table provides tips for solving common
problems.
PROBLEM CAUSE / SOLUTION
No sound/power • The volume is not set. Adjust the volume.
• The power cord is not properly plugged in. Plug in the power cord properly.
• Empty/incorrectly inserted batteries. Insert fresh batteries correctly.
• The CD contains data other than music fi les. Try using buttons
• Make sure that the mode switch is set to correct position. Besides tape player mode,
The CD display • There has been an electrostatic discharge. Turn the device off and unplug from the
does not work
properly / no • CD is not inserted. Insert CD.
reaction to • The CD is heavily scratched or dirty. Change or clean the disc, see "Maintenance".
controls • Fogged laser lens. Wait until the humidity evaporates.
• CD-R/CD-RW disc is empty or not enclosed. Use only the enclosed CD-R / CD-RW
• Make sure that the CD is not encrypted with copyright protection technologies, as
• Switch the selector in the position TAPE (OFF) and then back in the CD position or
The CD skips • CD disc is damaged or dirty. Replace or clean the disc.
tracks • A program is active. Deactivate program.
• Badly scratched or dirty disc may cause a malfunction.
Bad sound quality • Dust and dirt on the cassette player heads. Clean the cassette mechanics, see the
from the cassette
• You are using unsuitable types of cassettes (METAL, CHROME). Use only standard
The recording • The cassette tabs are broken. Seal the tab opening with adhesive tape.
does not work
audio fi les.
the TAPE (OFF) position means also that the device is turned off .
socket. Switch it on after a while.
discs or suitable CD Audio discs.
some of these discs do not meet the standards of the CD format.
TUNER.
section "Maintenance".
cassettes of IEC type I (NORMAL) for recording.
GB
skipping to
57