Assembling The Guide Bar And Saw Chain - Oregon PS750-092 Manual Original De Instrucciones

Assembling the Guide Bar and
Saw Chain
WARNING: An electric power tool
that is plugged in can start accidentally.
Unplug the pole saw before preparing for
use or performing maintenance.
Wear gloves.
• Unplug the pole saw.
• Loosen the side cover release knob slightly,
but do not remove the side cover.
• Loosen the chain tensioning ring as far as it
will go.
• Loosen the side cover release knob and
remove the side cover.
• Place the guide bar on the bar pad by sliding
the bar slot over the alignment flange (Fig. ),
with the mounting stud inserted through the
slot in the guide bar.
FIG. 5
ALIGNMENT FLANGE
MOUNTING STUD
14
Preparing for Use
• Loop the new saw chain onto the drive
sprocket so that the cutting edges of the
teeth along the top of the bar face away from
the powerhead (Fig. ).
FIG. 6
• Feed the chain into the groove of the bar and
slide the bar away from the motor to remove
slack from the chain (Fig. ).
FIG. 7
BAR PAD
• Install the side cover, making sure the chain
catcher and side cover tab are seated in their
proper locations, then lightly tighten the side
cover release knob (Fig. ).
FIG. 8
Pole Saw Model PS750-092