Using The Appliance For The First Time - WMF Ambient Instrucciones De Uso

Using the appliance for the first
time
▪ Before using the appliance for the first time, clean the lid
and the water tank as described in the section "Cleaning
and care".
▪ Connect the appliance using the power cable and connect
the mains adapter. Make sure that no electrically conduc-
tive objects are placed near the appliance, and ensure that
the cable is not twisted in order to guarantee trouble-free
use of the WMF Easy Touch technology.
▪ Remove the lid, fill the water tank with water to the
MAX marker and add around three drops (recommended
amount for a 90-minute fragrance experience) of an
essential oil (adjust intensity of fragrance by means of
number of drops of oil).
Warning: Never pour essential oils directly onto the ultra-
sonic converter on the base of the water tank.
Note: You can operate the appliance with an empty water
tank. In this case, the atomisation function is deactivated and
you can use the appliance as a decorative element.
▪ With a full water tank, the atomisation function can
run for around four hours (adjust the amount of water
accordingly, depending on the desired atomisation time).
After four hours of atomisation, leave the appliance to
stand for 30 minutes.
▪ Then reposition the lid and rotate the mist outlet in the
required direction.
Warning: If you operate the diffuser without the lid in place,
this could cause the mixture of water and oil to discharge
uncontrollably out of the appliance. The mixture of oil and
water can damage furniture.
▪ If the touch button is gently touched, the appliance is
switched on.
▪ Atomisation begins immediately, the white Ambient light
illuminates and the timer is preset to ∞.
▪ Atomisation continues until the water tank is empty. The
white Ambient light remains on in accordance with the
timer setting (∞) until the appliance is switched off.
▪ If the touch button is gently touched, the appliance is
switched off.
▪ If no personalised settings are made for the Ambient light
as described in the section "Personalised setting", the
presetting remains active.
16
Personalised setting
You can adjust the timer or the colour of the Ambient light
to your own personal preference.
▪ To change the presetting, you must switch the appliance
into setting mode. To do this, touch the touch button for
at least two seconds, until you hear a sound. The appli-
ance is now in setting mode.
Ambient light timer setting
You can now set the illumination duration of the Ambient
light to 30, 60 or 90 minutes or to an unlimited time (∞).
▪ By gently touching the touch button, the timer display
changes from "30" to "60", from "60" to "90", from "90"
to "∞" until you reach the desired setting.
Example: If you touch the touch button while the timer
display is lit, the Ambient light is programmed to switch
off after 60 minutes.
▪ A sound is emitted to confirm the setting.
Ambient light colour setting
▪ The LED surfaces (Ambient light) start to light up and the
colour slowly begins to change.
▪ All seven colours light up one after the other. You can
select the desired colour by gently touching the touch
button.
▪ The cycle of seven colours is repeated three times. You can
select the desired colour setting during these cycles.
Note: After each cycle, the Ambient light switches off
briefly. If you wish to use the atomisation function
without the Ambient light, you must touch the touch
button while the Ambient light is switched off. A sound is
emitted to confirm the setting.
If you do not perform any specific colour settings during
the three colour cycles by gently touching the touch
button, the colour cycle is selected as the colour setting.
A sound is emitted to confirm the setting.
▪ The stored, personalised setting is programmed for future
use of the aroma diffuser.
17