Idiomas disponibles
Idiomas disponibles
4. Operating the brake
Press the lever down to engage the brake.
Press the lever up to disengage the brake.
5. Attaching and converting the seat
Attach the seat by placing it on the frame until it clicks into place.
To remove and convert the seat, pull the levers on both seat unit
adapters and lift up the seat.
6. Attaching the hood
Fit the hood on the seat frame with the two plastic brackets.
7. Fitting and removing the guard rail
Fit the guard rail by inserting it in the plastic mounts on both sides.
To remove the guard rail from the pushchair, press in the buttons on
both sides and pull the guard rail off away from the pushchair.
8. Fitting and changing the Tec Comfort Set
Seat liner:
a) Undo the strap. For more information, follow the instructions in
section 11.
b) Then pull the crotch belt through the opening in the seat liner.
c) Fix the tab on the head end of the seat liner with the Velcro fastening
on the backrest.
Sun vizor:
d) There are three Velcro fastenings and two snap fasteners on the sun
vizor and cover. Fasten them together.
Guard rail cover:
e)Fit the cover around the guard rail and secure it in place with the
Velcro fastening.
EN - 10
4
4
5
5
6
7
7
8
b
8
c
8
d
8
e
9. Adjusting the leg rest
To adjust the leg rest, press in the buttons on both sides and then
adjust the height.
Let go of the buttons again so that the leg rest clicks into place.
10. Fastening the harness
To fasten the harness, bring the top two plastic catches together and
interlock them.
Then insert the interlocked catches into the bottom part of the
fastening.
Adjust the harness to a setting where the baby is held in the correct
position.
11. Unfastening the harness
To open the harness, press the button on the side.
CAUTION: Always use the shoulder harness and lap belt together.
12. Adjusting the seat unit
To adjust the seat unit, press and hold down the catches on both
sides of the seat unit and adjust the height of the seat. When you have
reached the required position, let go of the catches to allow the seat to
remain in that position.
Carrycot
13. Opening the carrycot
Lift the side panels of the carrier.
Extend and secure the side panels by pushing the two retainers
outwards into the mountings.
Make sure that the retainers are securely engaged.
14. Attaching the cot bumper
Lay the bumper in the cot, folding the top part over the edge of the
carrycot.
Fasten the four press studs on the rear.
9
10
10
11
12
13
14
EN - 11
