Beper 50.940GO Manual De Instrucciones página 10

Multifunctional steam brush Use instructions
Product description Fig.1
1. Steam brush body
2. Water tank cover
3. Water Tank
4. Indicator light
5. Steam button
6. Ergonomic handle
7. Power cord
8. Steam brush stand
9. Brush removing button
10. Temperature knob
11. Teflon soleplate
12. Brush with bristles
13. Cloth brush
INSTRUCTIONS FOR USE
INSERT AND REMOVE BRUSHES Fig. 2
In addition to the Teflon plate, the product is equipped with two optional brushes.
To apply the brush, place it on the Teflon plate, press lightly until a click is heard.
To remove the brush, press the brush removing button and pull the brush outwards.
!CAUTION!
The brushes must be inserted and removed only when the steam brush is cold. Always make sure
that the power cord is disconnected from the power supply when you do this.
FILL THE WATER TANK
Make sure the power cord is not plugged into an electrical outlet.
Lift the tank lid and fill the tank with water. Do not fill above the MAX level indicated on the measuring
cup.
Use only demineralised water. Do not add chemical additives to water (detergents, liquid soaps,
perfumes, etc.) as they can damage the steam brush and be dangerous.
Close the tank lid.
If the water in the tank runs out during use, disconnect the power cord from the electrical outlet and
allow the steam brush to cool. Then fill the tank with water (as indicated above).
OPERATION Fig. 3
Insert the power cord into an electrical outlet.
Set the desired temperature by turning the adjustment knob, when the indicator light goes out, the
steam brush has reached the optimal temperature and it is therefore possible to use it.
When the steam brush is connected to the mains, some steam may come out of the holes in the
body even if the steam button has not been pressed.
By pressing the steam button at regular intervals (about every 2 seconds) the brush will generate
the steam jet. For a better use of the steam jet, it is advisable not to press the steam button for more
than 5 consecutive times.
The steam brush can be used both vertically and horizontally.
When using the steam brush, the indicator light can light up to indicate that the brush is not at the
optimum temperature; wait a few seconds for the light to come on.
10