Controls And Connections; Front Panel; Rear Panel - Asystems DMP81 Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

3. CONTROLS and CONNECTIONS

FRONT PANEL

1.
Input Level Control 1 - 8
Every input channel is equipped with a rotary knob for
adjusting the final input level.
2.
ON LED 1 - 8
Every input channel is equipped with an ON LED
which lights green when a signal is present in the input
channel, and will turn red when the signal peaks�
3.
HPF (High Pass Filer) Control 1 - 8
Make adjustment by using slot screwdriver�
4.
High Frequency Shelving Filter 1 - 8
Make adjustment by using slot screwdriver�
5.
AUX Level Control
This rotary knob for adjusting the AUX input level�
6.
SG LED (for AUX INPUT)
This LED will light up green when an output signal is
present and red when the signal peaks�
7.
AUX INPUT 1/4" TRS Phone Jack

REAR PANEL

15. AC Power Connector
The unit is supplied with power via a standard IEC
power cable from power source�
16. DIP Switch 1 (for adjusting setup options)
See section "DIP Switch"�
17. DIP Switch 2 (for turning phantom power ON/OFF)
See section "DIP Switch"�
18. MASTER OUT
DMP81 offers a single 3-pin Euroblock output
connector� This connector can be set as balanced or
unbalanced� (see section Installation and Setup)�
8.
LIMITER LED (for MASTER OUTPUT)
Lights red when on-board limiter actives�
9.
SG LED (for MASTER OUTPUT)
This LED will light up green when an output signal is
present and red when the signal peaks�
10. MASTER Level Control
This knob controls the level for MASTER output��
11. POWER LED
This LED indicator will illuminate when the DMP81 is
activated�
12. Power switch
Flick this switch to switch the unit on and off.
13. PHONES Level Control
This knob controls the level for the PHONES output
jack�
14. PHONES OUTPUT 1/4" TRS Phone Jack
For connecting headphone�
19. INPUT Connector 1 - 8 (Euroblock)
See section "Installation and Setup"�
20. INPUT Connector 1 - 8 (Balanced 1/4" TRS Insert
Jack)
See section "Installation and Setup"�
21. MIC-IN/LINE-IN Switch
Every input channel is equipped with a button switch
for setting MIC-IN/LINE-IN� For MIC-IN, set this button
to
MIC, for LINE IN, set this button to
3
DMP81
LINE�
English

Capítulos

Tabla de contenido
loading

Tabla de contenido