Max PowerLite AKHL1050E Manual De Operaciones página 7

21. DO NOT WIPE PLASTIC PARTS WITH SOLVENT
Solvent such as gasoline, thinner, benzine, carbon tetrachloride, and alcohol may damage and crack plastic
parts. Do not wipe them with such solvents. Wipe plastic parts with a soft cloth lightly dampened with soapy
water and dry thoroughly.
22. USE ONLY GENUINE REPLACEMENT PARTS
Replacement parts not original may void your warranty and can lead to malfunction and resulting injuries.
Genuine parts are available from your dealer.
23. DO NOT MODIFY THE COMPRESSOR
Do not modify the compressor. Always contact the authorized service center any repairs. Unauthorized
modification may not only impair the compressor performance but may also result in accident or injury to
repair personnel who do not have the required knowledge and technical expertise to perform the repair
operations correctly.
24. TURN OFF THE SWITCH WHEN THE COMPRESSOR IS NOT USED
When the compressor is not used, turn the switch OFF, disconnect the plug from the power source and open
the drain cock to discharge the compressed air from the air tank.
25. NEVER TOUCH THE SURFACE OF THE HIGH-TEMPERATURE SECTION
In order to prevent a burn, do not touch the piping, head, cylinder, motor and inverter case(lower cover).
26. DO NOT DIRECT AIR STREAM AT BODY
Risk of injury, do not direct air stream at persons or animals.
27. DRAIN TANK
Drain tank daily or after 4 hours of use.
Open drain fitting and tilt compressor to empty accumulated water.
28. DO NOT STOP COMPRESSOR BY PULLING OUT THE PLUG
Use the " ON/OFF " switch.
29. USE ONLY MAX POWERLITE NAILERS, POWERLITE HOSE AND MAX GENUINE PARTS FOR MAX
POWERLITE COMPRESSOR
30. REPLACEMENT PARTS
When servicing, use only MAX genuine parts. Repair should be conducted only by authorized service center.
31. NEVER USE A TRANSFORMER
32. NEVER CONNECT THE COMPRESSOR TO AN ENGINE GENERATOR OR DIRECT-CURRENT POWER
SUPPLY
The compressor will break or be damaged from burning.
33. DO NOT INSTALL THE COMPRESSOR IN ANY PLACE EXPOSED TO RAIN OR SPLASHED WATER,
HIGH-HUMIDITY PLACE OR HIGH-TEMPERATURE PLACE
If used in the wet condition, it could produce an electric shock or be short-circuited, resulting in ignition. Use
it under the environmental conditions provided by its specifications.
7