Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Commissioning
• Before taking the Battery Charger into use,
check that all items are complete/available and
free of visible damage.
• Place the Battery Charger on a straight, level,
scratch and slip resistant surface.
Notice:
This appliance is equipped with non-slip rubber feet.
As furniture surfaces may be made of a variety of
materials and are treated with many different types
of cleaning agents, it cannot be completely ruled
out that some substances contain ingredients which
may corrode the rubber feet and soften them. If pos-
sible, place an anti-slip material under the device.
• Compare the technical data with that of your
current mains power supplier. If they are the
same, connect the power cable to a mains
power socket. The LEDs blink red three times.
The Battery Charger is now ready for use.
Charging batteries
Danger!
Charge exclusively rechargable batteries of the
types „Ni-Cd" and „Ni-MH".
NEVER recharge batteries of other types or non-
rechargable batteries. These are not suitable for
recharging. They could irreparably damage the
Battery Charger and the inserted batteries. There is
also the danger of a fire as well as an explosion!
Notice:
Ensure that the batteries are inserted into the
charging slots in accordance with their polarities.
Otherwise, the batteries will not be charged.
• Insert the batteries into the charging slots.
• Press the 9 V Block batteries into the charging
slot until they audibly engage.
1 to 8 batteries can be individually charged:
• 4 x Type C or Type D batteries in the charging
slots 1 to 4, with additionally 2 x Type 9 Volt
Block batteries in the charging slots 5 and 6.
or
• 6 x Type AA or AAA batteries in the charging
slots 1 to 4, with additionally 2 x Type 9 Volt
Block batteries in the charging slots 5 and 6.
• The charging process now begins. The Battery
Charger has an LED for each charging slot. The
LEDs of the charging slots indicate the charge
state of the battery they contain.
• In the first 5 seconds the Battery Charger carries
out a capacity test:
- The LED of the charging slot glows green:
The battery capacity lies over 90 %.
- The LED of the charging slot glows orange:
The battery capacity lies between 80 % - 90 %.
- The LED of the charging slot glows red:
The battery capacity lies under 80 %.
- The LED of the charging slot blinks red
The battery is not properly inserted into the
charging slot or is defect.
When the battery capacity has been determined,
the charging process begins.
- 28 -
:
Capítulos
Tabla de contenido
