Straightening Hair; Safety Switch Off - Silvercrest SRHG 15 A1 Instrucciones De Uso

Straightening hair

■ Prepare the hair as described in "Before straightening".
■ Start with the lower hair pieces at the back of the head. Work over the sides
to the front.
1) Separate a ca. 3 cm wide hair strand.
WARNING - RISK OF BURNS!
► Ensure that you do not touch the scalp or other skin on the body with the
hot plates 4.
► During the procedure you may only take hold of the appliance by the
handle!
2) Clamp the strand of hair close to the scalp between the hot plates
press them together.
3) Draw the entire strand of hair through the hot plates
straightener downwards.
4) Repeat the process with each individual strand.
5) When you have smoothed all of the strands, slide the on/off switch
to "0".. The control lamp 3 extinguishes.
6) Remove the power plug from the wall socket.
7) Press the hot plates
position
Safety switch off
This appliance is fi tted with a safety switch-off .
After approx. 30 minutes, and without activation of the on/off switch 2, the
appliance switches itself off automatically. After approx. 25 minutes the control
lamp 3 starts to blink, to remind you it is about to switch off automatically.
Should you wish to continue using it for longer than 30 minutes, switch the appli-
ance off and then immediately back on. The 30 minutes start from the beginning
again.
NOTICE
► The safety switch-off is not intended to replace switching the appliance
off manually with the on/off switch 2! It is only for your safety, should you
forget to switch it off !
SRHG 15 A1
4 together and slide the restraining device 1 to the
.
4 and
4 by pulling the hair
2
GB
MT
37