EIBENSTOCK ETS 225 Instrucciones De Servicio página 16

Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage
the arrestor button
Switching-off: press the on/off switch and let it go off again
Attention!
In case of every stop of the machine or a power cut, the lock button
has to be released immediately by pressing the on/off switch.
Consequently, you can avoid an unintentional restart of the machine
(physical hazard).
The machine is equipped with an electronic switch. With this switch the
speed can be regulated according to the pressure on the button. Only use
the electronic switch when you want to start the machine slowly.
Permanent use with reduced speed can cause an overload because the
motor then gets less cooling air and therefore the machine will be
overheated much faster.
Tool Change
Attention!
Before the beginning of all works disconnect the plug from
the mains!
Only use original accessories in order to allow an optimal extraction.
Changing the rubber foam pad and the base plate:
Rubber foam pad:
Press the sanding paper in a way on the
rubber foam pad that the extraction holes
are not covered.
The 6 hole punch of both discs makes it
possible to centre exactly and to position
the sanding paper on the machine easily.
If existing, first remove the sanding paper
and then the rubber foam pad carefully.
When fixing the new pad, flange nut and
punched holes of the base plate make the
positioning easier.
15