Tripp-Lite PDUMH15 Manual Del Propietário página 2

Installation
Note: The illustrations may differ somewhat from your PDU model.
1
Determine Installation Configuration.
The PDUs covered by this owner's manual
support these installation configurations: 2U,
1U and 0U rackmount; wall-mount and under-
counter. See below
configurations pertaining to your specific
model. Choose a configuration and follow the
installation instructions in the appropriate
section of Step 1 before proceeding to Step 2.
Note: Regardless
configuration, the user must determine the
fitness of hardware and procedures before
mounting. The PDU and included hardware
are designed for common rack and rack
enclosure types and may not be appropriate
for all applications. Exact mounting
configurations may vary.
1-1
2U Rack Installation. Attach the
included brackets to the side of the PDU with
the included screws (A). After installing the
brackets, position the PDU in the rack and
install four user-supplied screws through the
unit's brackets and into the rack rails (B).
1-2
1U Rack Installation. Attach the PDU
to the rack by inserting four user-supplied
screws (A) through the PDU mounting
brackets (B) and into the mounting holes of
the rack rail as shown.
1-3
0U Rack Installation. Part 1: Remove
the screws (C) attaching the mounting
brackets to the PDU, change the orientation
of the brackets as shown and reattach the
brackets. Use only the screws supplied by
the manufacturer or their exact equivalent
(#6-32, 1/4" flat head). Part 2: Attach the
PDU vertically by inserting two or more
user-supplied screws (A) through the PDU
mounting brackets (B) and into mounting
points in the rack or rack enclosure.
1-4
Wall Installation. After repeating Part 1
above, attach the PDU to a stable mounting
surface by inserting two or more user-
supplied screws (A) through the PDU
mounting brackets (B) and into secure
mounting points on the mounting surface.
1-5
Under-Counter Installation. After
repeating Part 1 above, attach the PDU to a
stable mounting surface by inserting four
user-supplied screws (A) through the PDU
mounting brackets (B) and into secure mounting points on the mounting surface.
201103062 93-3059.indd 2
for installation
of installation
1-1
1-2
1-3
1-4
1-5
2
B
B
B
B
C
A
A
B
A
C
A
C A
C
4/29/2011 2:33:40 PM