Troubleshooting - Triton TWX7 RT001 Instrucciones De Uso Y De Seguridad

Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any inspection,
maintenance or cleaning.
General inspection
• Check regularly that all the fixing screws are tight and all parts are undamaged and in good condition. Do not use
the router table until any faulty, damaged or heavily worn parts are replaced
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be carried out by an
authorised Triton service centre. This advice also applies to extension cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and shorten the machine's
service life. Clean the body of your machine with a soft brush, or dry cloth. If available, use clean, dry, compressed
air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol or strong cleaning
agents
• Never use caustic agents to clean plastic parts

Troubleshooting

Problem
No function when power turned on
Table module is not level
Unknown mechanical noise
Large amount of chippings and dust in use
Poor quality results
Workpiece difficult to control
Guarantee
To register your guarantee visit our web site at
tritontools.com* and enter your details.
Your details will be included on our mailing list (unless indicated otherwise)
for information on future releases. Details provided will not be made available to any third party.
Purchase Record
Date of Purchase: ___ / ___ / ____
Model: TWX7RT001 Retain your receipt as proof of purchase
Possible cause
No power
Router unit's power switch is off
Levelling screws are not correctly adjusted
Rough surface
Check router cutter is correctly fitted
Other fittings have worked loose
Router has worked loose from router mounting
Check vacuum system bag or cylinder is not full
Check dust extraction is switched on
Check dust extraction is properly connected
Check router cutter is sharp and in good condition
Check router speed is correct
Cut is too deep per pass
Workpiece incorrectly positioned
Fence incorrectly positioned
Workpiece direction incorrect
Featherboards not correctly used
art pr
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional and are not viable
for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to dispose of power tools
Check power supply
Reset router power switch
Refer to 'Levelling the router module' section
Ensure the Workcentre is situated on a secure flat surface. Relocate the table if the ground is found to be rough
Tighten collet assembly
Check fittings
Secure router correctly and tighten fittings
Replace bag or empty cylinder
Switch on
Make sure everything is correctly assembled along the whole dust extraction assembly and hose
Replace if dull or worn
Set the speed correctly on router unit
Complete work in multiple passes
Read Router Table Safety section and also refer to your original Router Manual for additional safety information
Triton Precision Power Tools guarantees to the purchaser of this product that if any part proves to be
defective due to faulty materials or workmanship within 3 YEARS from the date of original purchase,
Triton will repair, or at its discretion replace, the faulty part free of charge.
This guarantee does not apply to commercial use nor does it extend to normal wear and tear or damage as
a result of accident, abuse or misuse.
* Register online within 30 days.
Terms & conditions apply.
This does not affect your statutory rights oves to be defecti
Solution
GB
5